Parts for your 2025 Mitsubishi Eclipse cross-Wheel bearings

2025 Mitsubishi Eclipse Cross wheel bearings

Technical sources, including Mitsubishi Motors’ workshop/service manual for the Eclipse Cross and the dealer electronic parts catalogue, confirm the 2025 Mitsubishi Eclipse Cross is fitted with wheel bearings. Specifically, it uses sealed hub-and-bearing units at each wheel—pre‑greased, non‑serviceable, and commonly integrated with a magnetic ABS encoder ring. These are standard on both 2WD and AWD variants. Because the bearing is part of the hub assembly, regular servicing focuses on inspection rather than repacking, and if wear is detected the whole hub unit is replaced to restore safety, quietness, and ABS/ESC accuracy.

Wheel bearings let the wheels spin freely while carrying vehicle weight and cornering loads. On the Eclipse Cross, the sealed hub design keeps out water and grit, suiting Aussie and Kiwi conditions from coastal spray to corrugated back roads. Healthy hubs help braking feel, reduce rolling noise, and protect tyres from cupping caused by vibration. They also provide the clean speed signals stability systems rely on.

• Typical signs of wear include a humming or growling noise that rises with road speed.
• Noise that changes while turning (louder when loading the failing side).
• ABS or stability control warnings tied to erratic wheel‑speed signals.
• Play felt at the wheel at 12 and 6 o’clock during a shake test.
• Uneven or cupped tyre wear and a slight steering shimmy.

Inspection is simple during routine servicing: road test, listen on smooth asphalt, check for play with the wheel lifted, spin the wheel by hand for roughness, and scan for ABS faults. In harsher use—gravel, heavy loads, kerb strikes—ask for a closer look every 15,000 km or annually.

• Replacement is as a complete hub assembly, the bearings aren’t repackable.
• Use quality OEM‑spec hubs with the correct magnetic encoder for ABS.
• Clean mating faces, torque the axle/stub nut and wheel nuts to spec.
• Don’t reuse single‑use axle nuts or bolts where specified.
• After fitment, road test and, if alignment was disturbed, request a check to protect tyres.

Look after the hubs with correct wheel nut torque, avoid deep water when hot, and steer clear of hard kerb hits—simple habits that help bearings last well beyond 100,000 km.

FAQ: Does the 2025 Eclipse Cross use serviceable bearings or sealed hub assemblies?

It uses sealed hub-and-bearing units at each wheel. They’re pre‑greased, non‑serviceable, and typically integrated with the ABS encoder. When worn, the whole hub assembly is replaced rather than repacked or adjusted.

FAQ: How long do wheel bearings last on an Eclipse Cross?

With normal driving, many last 100,000–200,000 kilometres. Rough roads, oversized wheels, frequent kerb hits, or water immersion can shorten life. Have them checked at each service and sooner if noise or play is noted.

FAQ: Is it safe to keep driving with a noisy wheel bearing?

Best not. A failing bearing can overheat, increase stopping distances, and trigger ABS/ESC faults. Book an inspection promptly, if there’s heavy rumble, heat, or noticeable play, arrange a tow to avoid further damage.