Your Selected Vehicle
Parts for your 2023 Honda Cr-v-Headlight bulbs
Explore 4WD & Adventure
Narva 9-33 Volt LED Rear Stop/Tail, Right Hand Squential direcion indicator and reverse lamps with in built retro reflector and 0.5m hard wired cable - 97312R
Narva Model 72 Rear Stop/Tail/Indicator Lamp With In-Built Retro Reflector, With 0.5M Of Cable
Narva Model 72 Rear Stop/Tail/Indicator/Reverse Lamp With In-Built Retro Reflector, With 0.5M Of Cable
2023 Honda CR‑V headlight-bulbs: what’s fitted and how to look after them
Referencing the 2023 Honda CR‑V Owner’s Manual and AU/NZ model specification sheets, this model was offered with two headlamp types depending on grade: halogen projector headlights that use replaceable headlight-bulbs, and full-LED headlights with sealed LED light sources. On halogen-equipped grades, headlight-bulbs are absolutely relevant service items. On LED-equipped grades, there’s no conventional bulb to swap—the unit is designed as a sealed assembly and servicing typically requires dealer attention.
For 2023 Honda CR‑V vehicles fitted with halogen headlights, headlight-bulbs do the heavy lifting for safe night driving and poor weather. They provide the low and high beam illumination that keeps the road clearly visible and helps others see the vehicle. Bulbs gradually dim with age, so even if they haven’t blown, a fresh set can noticeably improve night-time visibility.
When it’s time for a change, treating headlight-bulbs as routine maintenance makes life easier. Replace them in pairs so the colour and brightness match. Always confirm the correct bulb type for the exact grade and build in the owner’s manual or parts catalogue, and avoid touching the glass with bare fingers—skin oils can shorten bulb life. Under the bonnet, access is usually via a dust cover at the rear of the headlamp: remove the cover, disconnect the plug, twist the bulb anti-clockwise, and reverse the process to install. Don’t force anything, if it doesn’t seat smoothly, realign and try again.
After fitting, check the beam aim against a wall or garage door. If the cut-off looks off-centre or too high/low, have the alignment checked to avoid glare and to meet local road rules. If a new bulb doesn’t light, inspect the relevant fuses and connectors for corrosion or looseness. Notice condensation inside the lens? A little mist after heavy rain can be normal, but persistent moisture may indicate a seal issue—get it looked at to protect the new bulbs.
- Swap bulbs every few years or sooner if output drops.
- Carry quality spares on road trips, especially after dark kilometres.
- Stick with ADR/DOT-compliant bulbs, skip dodgy “blue” or non-compliant LED retrofits that can cause glare and fail WOF/regency checks.
- If your CR‑V has factory LED headlights, there’s no headlight-bulbs to replace—book diagnostics and repair with a Honda technician if the lamp faults.
FAQs
How can I tell if my 2023 Honda CR‑V has headlight-bulbs or sealed LED headlights?
Quick cues: halogen projector lamps usually have a bulb access cap behind the headlight and a warmer beam colour, while full-LED units have multiple small emitters and no removable bulb caps. The owner’s manual and grade specification list the headlight type—LED variants state the light source isn’t serviceable as a bulb.
What bulb types fit the 2023 Honda CR‑V with halogen headlights?
Many AU/NZ halogen-equipped grades use common bulb types for low and high beam, but the exact spec can vary by trim and build. Check the owner’s manual or parts guide for your VIN to confirm the correct fitment. When in doubt, take the old bulb to the parts counter to match it properly.
Can I upgrade my halogen headlight-bulbs to aftermarket LED bulbs?
It’s not recommended. LED “retrofit” bulbs in halogen housings often create glare, reduce beam focus, and may breach ADR/WOF requirements. For a legal, safe improvement, choose high-quality, compliant halogen bulbs or discuss approved upgrades with a licensed technician. If your CR‑V already has factory LED headlights, there’s no bulb to upgrade—any performance change involves the headlamp assembly and should be handled professionally.