Parts for your 2017 Mitsubishi Lancer-Coil springs

2017 Mitsubishi Lancer Coil Springs — What They Do and When to Replace Them

Technical sources confirm coil springs are absolutely relevant to the 2017 Mitsubishi Lancer. The Mitsubishi Motors Lancer Service Manual (CJ/CF series, Suspension – General Description), the 2017 Lancer Owner’s Manual Specifications, and MY17 Australia/NZ model brochures all describe a MacPherson strut front suspension and a multi-link rear suspension, both using coil springs. So yes, the 2017 Lancer runs coil springs on both axles.

On a 2017 Mitsubishi Lancer, coil springs carry the vehicle’s weight, set the ride height, and work with the struts/shock absorbers to keep tyres planted and the ride comfy. They’re a big part of how the Lancer feels over rough country roads, handles quick direction changes, and copes with daily commuting. Good coils help keep things level when the car’s loaded up, reduce nose-dive under brakes, and keep cornering predictable.

They’re tough parts and often last well beyond 150,000 km, but age, heavy loads, and coastal corrosion can take a toll. During routine servicing, it’s smart to inspect coils for rust pitting, flaky paint, cracked or broken ends, and collapsed or uneven ride height. Listen out for clunks over bumps and look for uneven tyre wear — both can hint at tired coils or related hardware like top mounts and spring seats.

• Always replace coil springs in axle pairs to keep handling balanced.
• Match springs to the exact Lancer variant (engine, trim, and any factory sport/suspension package).
• Have a wheel alignment done after replacement to protect tyres and restore steering feel.
• Consider renewing struts/shocks, top mounts, isolators, and bump stops at the same time if they’re worn.
• Springs must be compressed safely — leave it to a qualified tech with the right gear.

For most Lancers, a visual check at each service and a more thorough suspension inspection every 20,000–30,000 km keeps surprises at bay. If the car sits lower on one corner, scrapes driveways more than it used to, or feels floaty or harsh, it’s time to get the coil springs and related components assessed. Using quality parts and correct installation torque under vehicle load will keep that tidy Lancer ride and handling just the way it should be.

Do 2017 Mitsubishi Lancers have coil springs front and rear?

Yes. The 2017 Lancer uses MacPherson struts with coil springs up front and a multi-link rear with coil springs. This setup is documented in the CJ/CF Service Manual and the 2017 Owner’s Manual specifications.

How long do Lancer coil springs last, and when should they be replaced?

Many last well past 150,000 km, but corrosion, heavy loads, and rough roads can speed things up. Replace if there’s sagging ride height, a broken coil, heavy rust pitting, clunks over bumps, or uneven tyre wear. Inspect at each service and get a detailed check every 20,000–30,000 km.

Can just one coil spring be replaced on a Lancer?

It’s best to replace in axle pairs. Mixing an old spring with a new one can affect ride height and handling balance. Pairing new springs keeps steering feel and braking behaviour consistent.