Parts for your 2017 Mitsubishi Asx-Pedal pads

2017 Mitsubishi ASX pedal pads — purpose, upkeep and when to replace

Pedal pads are fitted to the 2017 Mitsubishi ASX. Technical sources including the Mitsubishi Motors Service Manual for ASX/RVR/Outlander Sport (MY2017, Groups 35A Brakes and 22A Clutch) and the Mitsubishi ASA Electronic Parts Catalogue for GA/CF platform models show a replaceable rubber brake pedal pad, with an additional clutch pedal pad on manual variants. This aligns with ADR 31/03 in Australia and NZTA VIRM (Brakes) guidance, which expect a non-slip pedal surface for roadworthiness.

On this ASX, the brake (and clutch, if manual) uses a rubber pad over the metal pedal arm to provide grip, comfort and consistent pedal feel. The accelerator is an electronic drive-by-wire unit with an integral hard surface, it’s not designed for a separate rubber pad. The pads do the simple but vital job of keeping the driver’s shoe planted—especially in the wet—reducing the chance of a slip that could lengthen stopping distance or make clutch control jerky.

As part of regular servicing, it’s smart to inspect pedal pads every 10,000–15,000 kilometres or at each service visit. Look for glazing that’s gone smooth, hardening, cracks, curled edges or a pad that twists on the pedal. Any of those can cop a defect during a WoF/CoF or roadworthy and should be replaced straight away. Drivers in sandy, muddy or coastal conditions may see faster wear, as grit chews into the rubber and salts harden it over time.

Replacement is straightforward: the old pad pulls off the pedal plate, the new one stretches over the lip and locks into the groove. Clean the metal pedal with mild soap and water or isopropyl alcohol first, avoid lubricants, silicone sprays or dressings that can leave it slippery. Use quality OEM-equivalent pads that meet the vehicle’s spec—oversize “universal” or metal dress-up covers can reduce grip or foul the pedal, and may not meet ADR/NZTA expectations. For automatics, only the brake pad is replaceable, for manuals, do both brake and clutch together for a consistent feel underfoot.

• Replace if the pad is shiny-smooth, cracked, loose, or if shoes slip when wet.
• Check floor mats don’t ride up under the pedals, anchor them properly.
• Avoid solvents and tyre shine on or near the pedals.

Does the 2017 Mitsubishi ASX have pedal pads on automatics and manuals?

Yes. Automatics have a replaceable rubber brake pedal pad. Manual models have replaceable pads on both the brake and clutch. The accelerator is an electronic pedal with an integral, non-removable surface.

How often should pedal pads be replaced?

There’s no fixed interval—replace on condition. Many owners see 2–5 years depending on driving and climate. If the surface is smooth, cracked, hard or slippery, swap it out at the next service to stay roadworthy.

Are universal pedal covers a good idea for an ASX?

Not recommended. Universal or metal dress-up covers can reduce grip or interfere with pedal travel. Stick with OEM or quality equivalents sized for the ASX to maintain proper fit and compliance.