Your Selected Vehicle
Parts for your 2009 Suzuki Splash-Headlight bulbs
Repco by Century Car Battery Superior Performance 500CCA - 55D23L MF
Repco by Century Car Battery 4x4 & SUV Ultimate Performance 760CCA - N70ZZLX MF
Repco by Century Car Battery Ultimate Performance 550CCA - 75D23L MF
Repco by Century Car Battery Ultimate Performance 710CCA - DIN65LHX MF
Repco by Century Car Battery Superior Performance 400CCA - NS60L MF
Explore 4WD & Adventure
Repco by Century Car Battery Ultimate Performance 600CCA - DIN53LHX MF
Repco by Century Car Battery Ultimate Performance 550CCA - 75D23R MF
Repco by Century 4x4 & SUV Battery Ultimate Performance 680CCA - NS70LX MF
Repco by Century Car Battery 4x4 & SUV Superior Performance 680CCA - N70ZZ MF
Repco by Century Car Battery Ultimate Performance 640CCA - DIN65LX MF
Repco by Century Car Battery Ultimate Performance 860CCA - DIN85LHX MF
Repco P21/5W Bayonet Off-set pins Globe 12V 21/5W BAY15d Pack of 2 - R380BLL
Repco by Century Car Battery Ultimate Performance 430CCA - NS60LSX MF
Repco by Century Car Battery Ultimate Performance 430CCA - NS60LX MF
Repco by Century Car Battery Stop Start & Hybrid AGM Battery 800CCA - DIN75LH AGM
Repco by Century Car Battery Ultimate Performance 430CCA - NS60SX MF
2009 Suzuki Splash headlight-bulbs
Based on technical sources – including the 2009 Suzuki Splash Owner’s Manual (lighting section), Suzuki’s electronic parts catalogue, and major bulb catalogues from Osram and Philips – the 2009 Splash uses conventional halogen headlight bulbs. Most 2009 models are specified for an H4 (12V, 60/55W) dual‑filament bulb handling both low and high beam. So, headlight-bulbs are absolutely relevant to this vehicle.
On a small city hatch like the Splash, the headlight bulbs do the heavy lifting for safe night driving and low‑light visibility. The H4 unit throws a broad, well‑defined dip beam for oncoming traffic and a clear high beam for open roads. As halogens age, they gradually lose brightness and shift colour, which can creep up on a driver without noticing until night vision takes a hit.
As part of routine servicing, it’s smart to inspect beam brightness and lens clarity, and consider replacing bulbs in pairs every couple of years or 30–50,000 kilometres, especially if there’s a lot of night or rural driving. Tell‑tale signs it’s time: dim or yellowish light, flickering, or one side failing. Sticking with the specified H4 60/55W avoids heat damage and electrical strain, and keeps the Splash compliant with ADR/ECE rules in Australia and New Zealand.
- Switch off the ignition, pop the bonnet, and let the lights cool.
- Reach the rear of the headlamp and peel off the rubber dust cap.
- Unplug the 3‑pin connector, release the spring clip, and withdraw the old bulb.
- Fit the new H4, aligning the tabs, avoid touching the glass. Clip it in, reconnect, and refit the dust cap.
- Test low and high beam, then check aim, adjust if needed per the manual.
Handy tips: replace both sides together for even colour and output, keep the dust caps seated to prevent moisture, and if bulbs fail early, have the battery/charging voltage checked. LED retrofit bulbs may seem tempting, but many are not road‑legal in reflector housings and can scatter light. If considering an upgrade, use ADR/ECE‑approved options or complete headlamp assemblies designed for LED/HID, and always verify local WOF/rego requirements. Market variations exist, so if in doubt check the owner’s handbook or the markings on the lamp housing.
What headlight bulb type fits a 2009 Suzuki Splash?
Most 2009 Splash models take an H4 halogen bulb rated at 12V 60/55W for combined low/high beam. Some market or trim variations exist, so it’s wise to confirm via the owner’s manual or the markings on the lamp cover before buying.
How often should the bulbs be replaced?
Halogen bulbs commonly fade over 2–3 years. Replacing in pairs every 30–50,000 kilometres keeps the beam even and bright. If one fails, the other is usually not far behind.
Can they switch to LED bulbs?
It’s possible, but many LED retrofits aren’t road‑legal in halogen reflector housings and can create glare. If upgrading, choose ADR/ECE‑approved solutions and check local WOF/rego rules to stay compliant.