Your Selected Vehicle
Parts for your 2009 Subaru Tribeca-Batteries
LED Autolamps Twin function side indicator with amber/red side marker - 97CARIMCSB
LED Autolamps 12/24V Front End Outline Marker Recessed Fitting Twin Blister - 7922WM2
LED Autolamps 12/24V Cat6 Side Direction Indicator Clear Lens Blister Pack - 77ACM
Explore 4WD & Adventure
LED Autolamps 12/24V Reverse Lamp Horizontal/Vertical Mount Twin Blister - 11WM-2
LED Autolamps Multi Volt Stop/Tail Lamp With Rubber Grommet And Plug - 164RM
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
LED Autolamps 24V Front Indicator And Park Light Chrome Bezel Blister Pack - 285CAW24
LED Autolamps 12V Stop/Tail Lamp Black Chrome Round With Clear Lens - 102RBC
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Lamp 460x130x33mm - 460ARWM
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
LED Autolamps 12/24 Multi Volt Stop/Tail Lamp 36 LEDs With 40cm Wire - 80RM
LED Autolamps 12V/24V Round LED Stop/Tail Lamp With Grommet and Plug - 110RMG
LED Autolamps 12V 82 Series Stop/Tail/Indicator/Reverse Lamp Black Bracket - 82BARW
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
LED Autolamps 12V Stop/Tail/Indicator/Licence Plate Lamp With Reflector - 149BARL4P
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIM
LED Autolamps 12/24V LED Reverse Lamp Screw Surface Mount Blister Pack - 12WM-2
2009 Subaru Tribeca batteries
Technical sources including the 2009 Subaru Tribeca Owner’s Manual and Subaru’s Factory Service Manual (Starting/Charging System sections), plus the scheduled maintenance guide, confirm this model is fitted with a 12‑volt lead‑acid starter battery. So yes—batteries are absolutely relevant to the 2009 Subaru Tribeca.
The battery’s job is bigger than just cranking the flat‑six to life. It stabilises system voltage for the ECU, powers lights and accessories with the engine off, and keeps security and memory functions alive. When it’s healthy, starting is quick, electronics behave, and the alternator isn’t overworked catching up after each drive.
As part of routine servicing, a battery test is a smart inclusion—checking open‑circuit voltage, conductance/CCA, and a charging system test under load. In Australian and New Zealand conditions, most Tribeca batteries last around 4–6 years, shorter if the vehicle does lots of short trips, towing, or sits for long periods. Keep terminals clean and tight, ensure the hold‑down is secure, and if the unit is serviceable (not sealed), electrolyte should sit above the plates with distilled water only.
When replacement time comes, match the physical size, terminal layout, and at least the original cold‑cranking amps. A quality AGM is a worthwhile upgrade if the car runs plenty of accessories, but a good flooded lead‑acid that meets spec is perfectly fine. Avoid “stop/start” EFB types—this model doesn’t use idle stop systems. Use a memory saver if you want to keep presets, otherwise, expect to reset the clock and radio, and the auto windows may need a quick relearn. The ECU may refine idle and fuel trims over a few short trips.
- Signs it’s due: slower cranking, dimming lights at idle, repeated jump‑starts, or test results below spec.
- Safe swap basics: ignition off, remove negative first, then positive, install positive first, then negative, lightly grease terminals, verify charging voltage ~13.8–14.6 V with engine running.
- Not driving often? A smart maintainer keeps charge without cooking the battery.
- Always recycle the old unit—most parts stores and workshops take them.
Popular questions about 2009 Subaru Tribeca batteries
What battery type and size suits a 2009 Subaru Tribeca?
It takes a 12‑volt automotive lead‑acid battery. Choose one that matches the tray size and terminal orientation, with CCA at least equal to the original spec. Many owners opt for a quality AGM for better vibration resistance, though a conventional sealed lead‑acid that meets the rating works well. When in doubt, check the owner’s manual or the label on the existing unit.
How long should the battery last?
Typically 4–6 years in AU/NZ. Heat, short urban trips, and added accessories can shorten life. After three years, add a battery test to each service so issues are caught before it leaves them stranded at the servo or school run.
Will anything need resetting after a battery change?
Usually just the clock, radio presets, and auto window functions. The engine control module will fine‑tune idle and fuel trims over a few drives, which is normal. If a memory saver is used during the swap, most settings are retained.