Parts for your 2009 Honda Elysion-Brake calipers

2009 Honda Elysion brake calipers — purpose, service tips and when to replace

Technical sources including the Honda Elysion (RR1–RR5) factory service manual (Brakes section), the Honda Electronic Parts Catalogue, and reputable parts catalogues used by workshops confirm that the 2009 Honda Elysion runs disc brakes with calipers front and rear. So brake calipers are absolutely relevant to this model.

On the 2009 Honda Elysion, the brake calipers are the hardworking bits that turn hydraulic pressure from the master cylinder into clamping force at the rotors. Typically a floating design for this generation, the piston pushes the inner pad while the caliper body slides on guide pins to pull the outer pad in. That balance keeps braking smooth and consistent, and plays nicely with the Elysion’s ABS and stability systems to keep things straight and tidy under heavy stops.

When it comes to servicing, good caliper health is non‑negotiable. During routine brake work, a technician should check for even pad wear, inspect and clean the caliper slides, and re‑grease the guide pins with a high‑temp, rubber‑safe caliper grease. The dust boots and piston seals need a close look—any tears or swelling can let moisture and grit in, leading to sticky pistons and cooked pads. Brake fluid should be flushed about every two years to keep internal corrosion at bay and maintain a firm pedal.

If the Elysion pulls to one side, shows uneven pad wear, or there’s a brake dragging smell after a short drive, the calipers deserve attention. Minor sticking can sometimes be resolved with a proper strip, clean, and lubrication of slides and pad abutments. But if a piston is pitted or seized, or a bleed screw is rounded or leaking, a quality replacement or remanufactured caliper is the smarter, safer call. Always torque mounting bolts correctly, replace copper washers on banjo fittings, and bleed the system thoroughly. After any brake work, bedding in new pads on freshened rotors will optimise bite and reduce noise.

• Watch for: uneven pad wear, pulling under brakes, hot wheel after driving, fluid weep at hose or bleeder, and a soft or wandering pedal.
• Service tips: clean and lube slides every 12 months/20,000 km, flush fluid every 2 years, and use only EPDM‑safe greases and fluids.

Popular questions

Do all 2009 Honda Elysion models have rear brake calipers?
Yes. Technical references for the RR‑series Elysion list disc brakes front and rear with calipers. If unsure, a quick visual check through the rear wheel confirms the caliper and rotor are present.

How often should caliper slide pins be lubricated on a 2009 Elysion?
As a rule of thumb, inspect and lubricate the slide pins every 12 months or 20,000 km, and any time pads are replaced. Use a high‑temperature, synthetic or silicone caliper grease that’s safe for EPDM rubber boots.

Can a sticking caliper trigger ABS or stability warnings?
Indirectly, yes. A dragging wheel can overheat, wear unevenly, and upset wheel‑speed signals, which may set warning lights. The root cause is mechanical, so fixing the caliper issue usually resolves the warning after a proper scan and road test.