Parts for your 2002 Nissan Bluebird-Sump plug washers

2002 Nissan Bluebird sump plug washers — what they do and how to look after them

Yes, the 2002 Nissan Bluebird uses a sump plug washer. Technical sources back this up: the Nissan Bluebird Sylphy (G10, circa 2000–2005) Service Manual (Lubrication LU and Maintenance MA sections) calls for replacing the drain plug gasket whenever the engine oil is changed, and the Nissan Electronic Parts Catalogue (FAST) lists a crush-type drain plug gasket for these models (commonly 11026-01M02 or 11026-4N200 for M14 plugs). These references cover Bluebird/Sylphy models with QG-series engines typically seen in NZ and Aussie markets via JDM imports.

A sump plug washer is a small, single-use crush gasket that sits between the sump (oil pan) and the drain plug. When the plug is tightened, the soft aluminium or copper washer deforms to create a tight seal. That crush action is what keeps engine oil from weeping out under heat, vibration, and pressure changes. Reusing a flattened washer can lead to slow drips, messy undertrays, and, in a worst case, a low-oil situation that’s bad news for any Bluebird’s engine.

For a 2002 Bluebird, treating the sump plug washer as a routine service item is cheap insurance. Best practice is to replace it at every oil change. If the old washer looks gouged, hard, or completely flattened, it’s past it. Aluminium and copper types both work, stick with a quality washer sized for the Bluebird’s M14 drain plug, and you’re golden.

• Washer type/size: M14 crush washer (Nissan examples: 11026-01M02, 11026-4N200). Confirm by VIN if unsure.
• Tightening torque: around 34 N·m (25 ft·lb) for many Nissan QG/QR engines, check the exact spec in the service manual for your variant.
• Fitment tips: clean the sump face, use one new washer only (don’t stack), thread the plug by hand first, then torque to spec.
• After the service: wipe down, run the engine, and check for any seepage after a short drive.

Whether it’s a daily commute in summer heat or a chilly South Island morning, the washer’s job is the same: keep the Bluebird’s oil where it belongs. Keeping a couple of spares in the glovebox or tool kit makes every DIY or workshop service that bit smoother.

Popular questions about 2002 Nissan Bluebird sump plug washers

What size sump plug washer does a 2002 Nissan Bluebird use?
Most 2002 Bluebird/Sylphy models use an M14 crush washer. Nissan commonly supplies 11026-01M02 or 11026-4N200 for these cars. Because regional variants exist, it’s smart to confirm by VIN or by checking the plug thread (typically M14 x 1.5).

How often should the sump plug washer be replaced?
Replace it at every oil change. It’s a single‑use crush gasket, once compressed, it won’t seal as reliably a second time. Fresh oil, fresh filter, fresh washer — that combo keeps the Bluebird tidy and leak‑free.

What torque should the Bluebird sump plug be tightened to?
As a guide, many Nissan QG/QR engines specify about 34 N·m (25 ft·lb) for the drain plug. Always verify the exact figure in the service manual for your specific engine code, and avoid overtightening to protect the sump threads.