Parts for your 2002 Daihatsu Yrv-Centre bearing

2002 Daihatsu YRV centre-bearing: is it fitted or needed?

For Australia and New Zealand–market 2002 Daihatsu YRV models, a centre-bearing (also called a centre support bearing for a two-piece propeller shaft) isn’t used. Technical documentation for the M200/M201/M211 YRV platform shows these cars are front‑wheel drive with a transverse engine and transaxle, so there’s no long prop shaft running to a rear differential and therefore no centre-bearing to service. This layout is confirmed in OEM workshop material for the YRV drivetrain and axle sections and by the Daihatsu Electronic Parts Catalogue (EPC) listings for 2002 Oceania models, which do not list a propeller shaft or centre support bearing for the 2WD YRV.

Worth noting: some front‑drive YRVs use an intermediate (right‑hand) driveshaft support bearing to stabilise the longer half‑shaft. That’s a different component to a prop‑shaft centre-bearing. The intermediate shaft bearing sits on the engine side of the right driveshaft, not mid‑car, and its maintenance falls under driveshaft/CV servicing rather than prop shaft support. If there’s noise or vibration under load on a local YRV, inspection should focus on CV joints and boots, wheel bearings, engine/trans mounts, and that intermediate driveshaft support bearing if fitted.

There was a 4WD YRV variant in certain overseas markets, which uses a propeller shaft and can have a centre support bearing. However, this configuration wasn’t standard for AU/NZ deliveries in 2002. If a privately imported 4WD YRV is in play, identifying parts by VIN and checking underbody hardware (rear differential present, two‑piece prop shaft with a carrier bracket mid‑floor) will confirm whether a centre-bearing is relevant.

Technical sources referenced: Daihatsu YRV (M200/M201/M211) Workshop/Repair Manual – Drivetrain and Axle sections, Daihatsu Electronic Parts Catalogue (EPC) for 2002 Oceania applications, OEM owner’s and service specifications describing the front‑wheel‑drive transaxle layout. These collectively support that a centre-bearing isn’t a service item on AU/NZ 2WD 2002 YRVs.

• No centre-bearing on AU/NZ 2WD YRV: front‑drive layout, no prop shaft.
• Common confusion: intermediate driveshaft support bearing ≠ centre-bearing.
• Focus servicing on CV joints/boots, wheel bearings, and mounts for driveline smoothness.

Popular questions about a 2002 Daihatsu YRV centre-bearing

Does a 2002 Daihatsu YRV have a centre-bearing?
For AU/NZ 2WD cars, no. They’re front‑wheel drive and don’t use a prop shaft, so there’s no centre support bearing. Only certain overseas 4WD variants have a prop shaft and may use a centre-bearing.

Is the intermediate driveshaft bearing the same as a centre-bearing?
No. The intermediate driveshaft support bearing (on some FWD YRVs) supports the right‑hand half‑shaft near the engine. A centre-bearing supports a two‑piece prop shaft in the middle of the car, which the 2WD YRV doesn’t have.

How can someone tell if their YRV needs a centre-bearing?
If it’s a 4WD import with a rear differential and a two‑piece propeller shaft running down the tunnel, it may use a centre-bearing. If it’s a typical AU/NZ 2WD YRV with only front driveshafts and no rear diff, there’s no centre-bearing to replace.