Parts for your 2001 Daihatsu Gran move-Exhaust mount

2001 Daihatsu Gran Move exhaust mount — what it does and how to look after it

Yes, the 2001 Daihatsu Gran Move definitely uses exhaust mounts (also called exhaust hangers or rubber insulators). This is evident in Daihatsu’s own Pyzar/Gran Move M100/M110 workshop literature under the exhaust system section, where the muffler and pipes are shown supported by rubber insulators on welded hanger rods. OEM parts catalogues (EPC diagrams) for the Gran Move also illustrate multiple exhaust mounting points from the front pipe through to the rear silencer. Reputable aftermarket catalogues from brands such as Bosal and Walker list replacement exhaust mounting rubbers for 1996–2002 Gran Move/Pyzar variants, further confirming fitment.

On this little Daihatsu, the exhaust mounts suspend the front pipe, centre section and rear muffler so the system can move slightly without thumping the floor or rear beam. Those rubber insulators isolate vibration, keep the tailpipe centred in the bumper cut-out, and protect rigid parts like the manifold and catalytic converter from stress. When mounts go soft, crack, or stretch, the exhaust sags, rattles over bumps, and can strike the body—annoying, and potentially damaging.

Servicing is straightforward. At each service or about every 10,000–15,000 kilometres, have a quick look underneath (when it’s cool) for perished rubber, elongated holes, torn edges, or a drooping tailpipe. Pay attention to the rear hanger at the muffler and the centre support near the resonator—these do the most work. Any sign of cracking or hardening is a cue to replace. It’s smart to change mounts in pairs if they’re the same age.

Replacement tips for a Gran Move:

• Support the exhaust with a jack and block of wood before removing any mounts.
• Use silicone spray to slip old rubbers off the pegs, avoid petroleum-based lubes that can attack rubber.
• Fit the correct-size mount, universal rubbers can work in a pinch but must match the peg spacing and thickness. Too-stiff polyurethane can transmit more vibration.
• After fitting, check clearances (aim for a finger-width around crossmembers, heat shields and the bumper) and ensure the tailpipe sits central.
• Re-tension any brackets to the torque specified in the workshop manual and inspect heat shields while you’re there.

A tidy set of mounts keeps the cabin quiet and prevents costly issues like cracked flex joints or separated seams on the muffler. It’s a quick, low-cost job that pays off every time you hit a rough Kiwi backroad or an Aussie corrugation.

Popular questions about 2001 Daihatsu Gran Move exhaust mounts

How many exhaust mounts does a 2001 Gran Move have?
Most Gran Move (Pyzar) models run three to four mounting points: a front support near the front pipe, a centre hanger around the resonator, and one or two at the rear muffler. Exact count can vary by engine and market trim, but if one is failing, check the lot.

What are the signs of a bad exhaust mount on a Gran Move?
Rattles over bumps, a dull thud on take-off, a drooping tailpipe, or the tip sitting off-centre are common giveaways. You might also notice extra vibration in the cabin. Left too long, the exhaust can contact the body and stress the flex joint, leading to leaks.

Can universal exhaust rubbers be used?
They can, provided the hole spacing, thickness and rod diameter match the Daihatsu pegs. For best NVH and fit, an OE-style rubber is recommended. Avoid overly hard mounts unless you’re chasing longevity over comfort.