Parts for your 2001 Daihatsu Yrv-Exhaust mount

2001 Daihatsu YRV exhaust mount — purpose, checks, and replacement

Technical sources confirm the 2001 Daihatsu YRV is fitted with exhaust mounts (rubber hanger insulators). The Daihatsu YRV M200/M201G workshop manual’s Exhaust section specifies removing the “exhaust hanger rubber” when dropping the muffler, the Daihatsu Electronic Parts Catalogue (EPC) for model code M201G (Group 17 – Exhaust) illustrates multiple hanger insulators along the system, and mainstream aftermarket catalogues (e.g., Bosal and Walker) list specific mounting rubbers for YRV models built 2000–2005. So an exhaust mount is absolutely relevant on a 2001 Daihatsu YRV.

On a 2001 Daihatsu YRV, the exhaust mounts are the tough little rubber isolators that suspend the exhaust under the car. Their job is to hold the pipes and mufflers at the correct height, soak up vibration, and let the system move slightly as the engine rocks and the exhaust heats and cools. That keeps rattles at bay and stops the pipes knocking the body, axle, or heat shields.

Typical locations on a YRV are a front hanger near the catalytic converter, a centre support under the mid‑pipe, and a pair on the rear muffler. Over time, heat, road grime, and coastal air can harden or crack the rubber. Tell‑tale signs include a tailpipe that sits low or off‑centre, a thud over bumps, buzzing at idle, or visible splits in the rubber. On turbo K3‑VET variants, the extra heat makes regular checks even more worthwhile.

As part of routine servicing, it’s smart to:

• Inspect the mounts every 10,000–15,000 km for cracking, elongation, or missing sections.
• Check the metal brackets and hooks for corrosion or bending, and ensure heat shields have clearance.
• Listen for knocks on start‑up, over speed humps, and at low RPM.

Replacement is straightforward: support the exhaust with a jack and block of wood, spritz the old rubbers with silicone spray, then lever them off the pegs. Fit like‑for‑like rubbers of OE style hardness, ultra‑stiff polyurethane can raise cabin drone on a small car like the YRV. If a single mount has failed, consider doing the set so the system hangs evenly. Re‑centre the tailpipe in the bumper cut‑out before tightening any bracket bolts. Always work on a cool exhaust and wear eye protection.

Done right, fresh mounts keep the YRV quiet, protect welds and flex joints from stress, and help the exhaust last longer between repairs.

Popular questions about 2001 Daihatsu YRV exhaust mounts

How many exhaust mounts does a 2001 Daihatsu YRV have?
Most YRV setups use three to four rubber mounts: one near the front pipe/catalyst, a centre hanger, and two at the rear muffler. Exact count can vary slightly with engine and market trim, but that layout is typical.

What are the symptoms of a failing exhaust mount on a YRV?
Common clues are a rattly exhaust at idle, a dull knock over bumps, the tailpipe sitting low or off‑centre, or visible cracks and stretched holes in the rubber hangers. You might also notice more vibration in the cabin.

Can universal exhaust hanger rubbers be used on a YRV?
Yes, if the dimensions and hole spacing match the pegs and brackets. For best fit and to keep noise levels civil, choose OE‑equivalent rubber hardness rather than overly stiff race‑style mounts.