Your Selected Vehicle
Parts for your 2000 Ford Falcon-Interior bulbs
Narva T-10mm W5W Premium Wedge Globe W2.1 X 9.5D 12V 5W Single Blister Pack - 17177BL
Explore 4WD & Adventure
Narva Marine 12V Saturn Dual Colour 75mm LED Interior Lamp with Touch Switch (White/Red) - 87501WRBL
Narva Marine 12V Saturn Dual Colour 130mm LED Interior Lamp with Touch Switch (White/Red) - 87503WRBL
2000 Ford Falcon interior bulbs
Interior bulbs are absolutely used on the 2000 Ford Falcon. The Ford AU Series II/III Falcon Owner’s Manual (2000) and Gregory’s Service & Repair Manual for Falcon AU (1998–2002) list courtesy/dome, map, glovebox and luggage compartment lamps as standard fitment, using small wedge and festoon globes. Parts catalogues from local suppliers also show common replacements such as W5W (T10) wedges and 31–36 mm festoon types for these locations, so they’re very much part of the car’s everyday kit.
These little bulbs do a lot: they light the cabin when doors open, help find seatbelt latches at night, make glovebox rummaging painless and brighten the boot so the esky or groceries aren’t a mystery. On most 2000 Falcons, expect a festoon globe in the dome/courtesy light and boot, with T10 wedge bulbs in the map lights and glovebox. Exact wattage and sizes can vary slightly by trim level, so a quick check against the owner’s manual or the existing bulb is the smart play.
Replacing them is a straightforward bit of DIY that slots nicely into regular servicing:
- Switch everything off and let hot bulbs cool to avoid burnt fingers.
- Use a plastic trim tool or small flat-blade screwdriver wrapped in tape to pop the lens without marking the trim.
- Note the bulb type and how it sits. Festoon bulbs push into spring clips, T10 wedges pull straight out.
- Avoid touching glass on halogen bulbs, use a tissue or gloves to keep oils off the surface.
- Before refitting the lens, test the light. If upgrading to LED, mind polarity—flip it if it doesn’t light.
A couple of handy tips for Falcon owners: stick close to the factory wattage so the lens doesn’t discolour from heat. If an interior light won’t work, check the bulb first, then the interior light fuse in the passenger fuse panel, and finally the door jamb switch or the lamp’s slider switch. LED upgrades can cut power draw and sharpen the look, quality CAN-style LEDs tend to dim more nicely with the Falcon’s courtesy fade. While you’re there, clean any greenish or dull contacts with contact cleaner for a brighter result. It’s a quick, satisfying refresh that keeps the cabin feeling tidy and usable after dark.
- What bulb types fit a 2000 Ford Falcon’s interior lights?
Most AU-series 2000 Falcons use 31–36 mm festoon bulbs (around 10W) for the dome and boot lamps, and W5W/T10 wedge bulbs (5W) for map and glovebox lights. Variants exist by trim, so matching what’s in the car is best. - Can the interior bulbs be upgraded to LED?
Yes. Choose warm-white LEDs for a factory look or cool-white for a modern vibe. Use quality, non-polarity or CAN-style LEDs for better dimming and less flicker. Keep sizes the same so lenses fit properly. - Why do the interior lights stay on or not come on?
Common causes are a blown bulb, a mis-set lamp switch, a tired door jamb switch, or a blown fuse. Try the simple checks first: bulb, lens switch position, then fuse, before chasing wiring faults.