Parts for your 2000 Daihatsu Gran move-Brake pads

2000 Daihatsu Gran Move Brake Pads

Based on technical sources including the Daihatsu Pyzar/Gran Move G3-series workshop manual (Brake section) and the Daihatsu Electronic Parts Catalogue for 1996–2002 models, the 2000 Daihatsu Gran Move is fitted with front disc brakes that use brake pads, while the rear uses drum brake shoes. Aftermarket fitment catalogues from major pad manufacturers also list front pads specifically for this model year, confirming brake pads are relevant to the vehicle’s front axle.

On the 2000 Gran Move, the front brake pads do the heavy lifting. They clamp the ventilated rotors to scrub off speed, converting the car’s momentum into heat. Quality pads help deliver a consistent pedal feel, straight-line stopping, and low noise—handy whether it’s the daily school run or a weekend dash up the coast.

As part of regular servicing, it’s smart to inspect the front pads every 10,000 km or at each service. Replace them when friction material is around 3 mm or less, or sooner if glazing, cracking, or uneven wear is present. Always check rotor condition at the same time—if there’s scoring, shudder, or the disc is at or below minimum thickness, organise a skim or replacement. Fresh fitting hardware, cleaned and lubricated slide pins, and new shims go a long way toward quiet, even braking. Use the brake fluid grade on the master cylinder cap (typically DOT 3 or DOT 4) and flush the system about every two years in Australian and New Zealand conditions.

• Tell-tales you need new pads: squeal or scraping, longer stopping distances, pulling to one side, or a soft pedal.
• During fitting: avoid contaminating friction surfaces, torque wheel nuts to spec, and ensure caliper slides move freely.
• After fitting: bed the pads in with several gentle stops from 60–20 km/h, avoid heavy braking for the first 200–300 km.

Choosing the right compound matters. For most Gran Move drivers, a reputable ceramic or low-metallic pad balances quiet operation, rotor life, and reliable bite in wet and dry. If the car tows or sees hilly terrain, consider a slightly higher-friction compound for stronger high-temperature performance.

Look after the front brake pads and the Gran Move will return the favour with confident, predictable stopping—no drama, just safe, tidy braking every day.

FAQs

Are the rear brakes on a 2000 Daihatsu Gran Move pads or shoes?
They’re drum brakes at the rear, which use brake shoes, not pads. Only the front axle uses disc brake pads on this model, as verified by the workshop manual and parts catalogues. If the rear struggles to hold on hills or the handbrake travel is excessive, it’s time to inspect the shoes and drum condition.

How often should front brake pads be replaced on a 2000 Gran Move?
There’s no one-size interval, as it depends on driving style and terrain. As a guide, check them every 10,000 km and plan replacement when the lining reaches about 3 mm. City commuting with lots of stops wears pads faster than open-road kilometres. Always inspect rotors alongside pads.

Do rotors need machining or replacing when fitting new pads?
If rotors are smooth, within thickness spec, and not heat-spotted, they can often stay in service. If they’re lip-worn, below minimum thickness, or cause pedal shudder, machine or replace them. New pads bed in best on fresh, true rotor faces, which helps reduce noise and uneven wear.