Parts for your 1999 Toyota Avensis-Pedal pads

1999 Toyota Avensis Pedal Pads

Pedal pads are indeed used on the 1999 Toyota Avensis (T22 series). The Toyota Electronic Parts Catalogue for the T22 (1997–2003) lists “Pad, Brake Pedal” and, on manual models, “Pad, Clutch Pedal”. Toyota’s factory repair literature for the Avensis also includes routine inspection of pedal pad condition, and both NZTA Warrant of Fitness and Australian roadworthy guidelines call out worn pedal rubbers as a defect. That confirms pedal pads are relevant and fitted to this model.

On a ’99 Avensis, the pedal pads are the grippy rubber covers pressed onto the metal brake pedal, and on manuals, the clutch pedal as well. They provide traction for the driver’s footwear, especially in wet weather, and help maintain consistent pedal feel. Automatics usually have just the brake pad, the accelerator is typically a moulded plastic tread rather than a separate rubber pad.

As part of regular servicing, it’s worth checking these pads for wear, hardening, or cracking. Over time, the rubber loses its bite, the ribs flatten, or the corners split, which can cause a foot to slip—never ideal in stop‑start traffic or on a rainy Kiwi or Aussie afternoon. If the pad surface is shiny, thin, or moves on the metal plate, it’s due.

Replacement is quick and inexpensive. With the engine off, tug the old pad off the pedal plate. Warm the new pad in hot water for a minute to soften it, then hook the top lip over the pedal and work the edges on by hand. Make sure the pad is fully seated all the way around—no rolled edges. For manuals, repeat on the clutch pedal. If the accelerator uses a separate tread on your variant, inspect it too, replace if loose or excessively worn.

Keep the pads clean by wiping away road grime and any silicone overspray from interior detailing, as that can make them slippery. If the car’s used in muddy or sandy conditions, check them more often. During WOF/roadworthy prep, inspectors look for secure fitment and adequate tread pattern, so fresh pads are a smart, low‑cost win for safety and compliance.

• Signs it’s time to replace: smooth/glazed surface, cracking, edges lifting, or noticeable foot slippage.
• Typical service interval: inspect every service, replacement as needed—often every few years depending on use.

FAQs

How often should brake and clutch pedal pads be replaced on a 1999 Avensis?
There’s no fixed kilometre interval. Inspect them at every service. In city driving with lots of clutch work, expect the clutch pad to wear faster. Replace when the ribs are flattened, the rubber is hard or cracked, or grip is reduced.

Are the brake and clutch pedal pads the same part?
They’re separate parts in the Toyota EPC and can differ in size and pattern. Order by VIN to ensure the correct pad for brake and, if manual, clutch. Automatic models typically only use the brake pedal pad.

Can pedal pads be replaced at home?
Yes. It’s a simple DIY job with no special tools. Warm the new pad to make it pliable, then stretch it over the pedal plate and confirm it’s fully seated. If it won’t fit easily, double‑check you’ve got the correct part.