Parts for your 2024 Ford Transit-Coil springs

2024 Ford Transit Coil Springs — What They Do and When to Service Them

Coil springs are relevant to the 2024 Ford Transit. Ford’s technical literature (Ford Workshop Manual 2024, Section 204-01 Front Suspension, and Body/Equipment Mounting Manual) specifies a MacPherson strut front end that uses coil springs, while the rear suspension remains a leaf-spring setup on cargo and most passenger variants. So, coil springs are fitted at the front and play a key role in ride, steering feel and load control.

On the Transit, the front coil springs carry vehicle and accessory weight (think racking, bull bars, ladder systems), keep the ride height in check, and work with the struts to absorb bumps. They also help tyres maintain contact with the road, which is critical for braking, steering and stability, especially with ANZ road conditions and variable payloads.

As part of servicing a 2024 Ford Transit, front coil springs should be visually inspected at routine intervals for corrosion, chipped powder coating, pitting, cracks—especially at the end coils—and any signs of sagging ride height. Owners or fleet managers might notice clunks over bumps, uneven tyre wear, a nose-down stance, or the steering feeling a bit darty when springs are tired or broken. There’s no fixed kilometre interval for replacement, it’s condition- and use-based. Vehicles operating near GVM, doing lots of kerb hops, or working in coastal areas benefit from more frequent checks.

• Match springs to the exact VIN/GVWR and front axle rating, Transits use different rates by T-150/T-250/T-350 and option loadings.
• Replace in pairs to maintain even ride height and handling.
• Inspect strut mounts, bearings and boots, often it’s efficient to refresh these with the springs.
• After any spring/strut work, get a wheel alignment to protect tyres and steering geometry.
• Avoid persistent overloading, it accelerates sag and can crack coils.
• If adding constant front weight (bar, winch), consider an approved higher-rate coil matched to compliance requirements.

Because the Transit’s front springs sit in a strut assembly under preload, proper compressors and safety procedures are essential—this is a job for a competent workshop. Using the correct spring orientation, isolators and torque specs from the Ford Workshop Manual ensures quiet operation and long life. Done right, fresh front coils restore ride height, improve steering feel, and keep the big van settled whether it’s running empty around town or hauling gear between sites.

Question: Does a 2024 Ford Transit have coil springs front and rear?

It uses coil springs at the front with MacPherson struts, as per the Ford Workshop Manual. The rear is a solid axle with leaf springs on cargo and most passenger variants. So coil springs are relevant to the front suspension only.

Question: When should the front coil springs be replaced on a 2024 Transit?

There’s no fixed kilometre interval—replace when there’s damage, sag, breakage, corrosion, or handling changes like clunks and uneven tyre wear. Heavy loads, kerb impacts and coastal corrosion speed up wear. Always replace in pairs and align the vehicle after.

Question: Can heavier-duty front coils be fitted for added accessories?

Yes—choose a spring rate that matches the VIN/GVWR and constant accessory weight, and keep within compliance for ADR/WOF. Quality matched springs with a correct alignment will maintain ride height and steering stability under added front-end load.