Parts for your 2023 Mitsubishi Eclipse cross-Tail lights

2023 Mitsubishi Eclipse Cross tail-lights

Technical sources confirm the 2023 Mitsubishi Eclipse Cross is fitted with tail‑lights: the Eclipse Cross Owner’s Manual (MY22/MY23) describes the rear combination lamps and bulb types, Mitsubishi Motors AU/NZ specification sheets list LED rear combination lamps, and the Australian Design Rules and UN ECE lighting regulations require rear position, stop and indicator lamps on road‑going vehicles. Tail‑lights are absolutely relevant to this model.

On the 2023 Mitsubishi Eclipse Cross, the tail‑lights do a lot more than glow red at night, they help other drivers judge distance, see braking and turning intentions, and they finish off the sleek rear styling Mitsubishi designed for the facelifted model.

Each rear combination lamp typically bundles the rear position (tail) lamp, stop lamp, indicator, reverse lamp and, on many AU/NZ specs, a rear fog lamp. Most variants use LEDs for fast response and long life, though some trims may still use replaceable globes for indicators or reverse. Either way, the vehicle’s lighting is designed to meet ADR/UN ECE rules for colour, intensity and visibility.

Keeping them in top nick is simple: give the lenses a regular wash, check that both sides illuminate evenly, and look for hairline cracks or moisture inside the housing after heavy rain or a trip through the car wash. If there’s condensation that doesn’t clear after a decent drive, the seal may be compromised and the unit should be inspected.

Got a dead globe or a light out warning? Start with the basics: confirm the function that’s failed (tail, brake, indicator, reverse), then check the relevant fuse and the connector at the rear lamp. On many Eclipse Cross models the tail and stop functions are sealed LED modules, these aren’t user‑serviceable and the assembly may need replacement by a technician.

For owner‑level replacement where a globe is used, this quick approach helps:

1. Park safely, switch everything off and open the tailgate.
2. Remove the trim access cover and undo the retaining fasteners, support the lamp as you withdraw it.
3. Disconnect the wiring plug, twist out the globe holder, and swap in the correct spec globe.
4. Reinstall, tighten fasteners evenly, then test tail, brake, indicators and reverse.

For LED assemblies, use genuine Mitsubishi parts to maintain ADR compliance and fit. Overtightening can crack the housing, so follow the service manual’s torque guidance, and never force a misaligned clip. After any rear knock or tow‑bar wiring install, it’s worth doing a full light check at night, as poor earths and trailer modules can cause weird intermittent faults.

Are the 2023 Eclipse Cross tail‑lights LED, and can owners replace the globes?
Most models run LED tail and stop lamps for quick illumination and durability. Some trims may use a replaceable globe for the indicator or reverse. If an LED function fails, the unit is typically replaced as an assembly, where a globe is fitted, owners can swap it with the correct spec. Always check the owner’s manual and use ADR‑compliant parts.

Where’s the tail‑light fuse on a 2023 Eclipse Cross?
There are fuse boxes in the engine bay and the cabin. Look for a fuse labelled TAIL, STOP or similar on the fuse map. Replace only with the same amperage. If the new fuse blows again, there’s likely a wiring, connector or lamp fault that needs diagnosis.

Can aftermarket or tinted tail‑lights be used in Australia or New Zealand?
Yes, but they must comply with ADR/UN ECE standards for colour and brightness: red tail/stop, amber indicators and white reverse, with correct intensity and visibility. Dark tints that reduce output can fail a WOF (NZ) or roadworthy/RWC (AU). Choose quality, compliant assemblies.