Parts for your 2022 Toyota Camry-Wheel bearings

2022 Toyota Camry wheel bearings

Technical sources from Toyota confirm the 2022 Toyota Camry is fitted with wheel bearings. The Toyota Repair Manual includes dedicated procedures under “Front Axle Hub and Bearing” and “Rear Axle Hub and Bearing,” and the Toyota Electronic Parts Catalogue lists complete hub-and-bearing assemblies for this model. These are sealed, bolt‑on hub units at all four corners, with the wheel speed (ABS) tone functionality integrated into the assembly.

On the 2022 Camry, the wheel bearings support the vehicle’s weight and let the wheel hub spin smoothly with minimal friction. Because they’re sealed units, they keep grease in and water and grit out, which helps them run quietly and last for years. The design also means there’s no periodic greasing, when a bearing wears out, the whole hub assembly is replaced.

As part of regular servicing, a good workshop will check for bearing noise, roughness and play. That typically involves spinning each wheel, listening for a low droning or growl, and lightly rocking the tyre to feel for movement at the hub. Sealed hub units aren’t a scheduled replacement item, but they do wear over time—often well past 150,000 kilometres depending on road conditions, loads and how the car’s driven.

• Common signs it’s time for a new hub/bearing:
  • A steady humming or droning that rises with road speed, often louder when gently loading one side of the car in a lane change.
  • Vibration through the cabin not linked to engine rpm.
  • Excessive play at the wheel when checked with the car lifted.
  • ABS or traction control warnings if the integrated tone feature is affected.

• Service tips for the 2022 Camry:
  • Use quality hub assemblies matched to the VIN, front and rear units differ, and hybrid variants may have unique specs.
  • Avoid kerb strikes and deep water that can stress or contaminate bearings.
  • During replacement, protect the ABS sensor and harness, clean mating faces, and torque fasteners and the driveshaft/axle nut to Toyota spec.
  • A wheel alignment usually isn’t required for hub replacement, but have it checked if suspension bolts were loosened or if tyres show uneven wear.
  • After fitting, road test for quiet operation and verify ABS data reads normally.

Look after the bearings with sensible driving and timely inspections, and the Camry will stay quiet, surefooted and safe on Aussie and Kiwi roads.

Popular questions about 2022 Toyota Camry wheel bearings

How long do wheel bearings last on a 2022 Camry?

On most 2022 Camrys, sealed hub bearings commonly run 150,000–250,000 kilometres. Life varies with road quality, loads, wheel impacts and tyre size. They’re not a scheduled service item, but they should be checked for noise and play at each service.

If the car sees rough roads, heavy loads or larger aftermarket wheels, expect a shorter lifespan. Early diagnosis saves the hub, ABS components and tyres from collateral damage.

What does a failing wheel bearing sound like on this model?

Typically a low hum or drone that gets louder with speed, often between 40–100 km/h. It may change pitch when you gently weave or load the car side to side. It’s different from a tyre roar, which often changes with road surface.

Advanced wear can bring a rumbling feel, uneven tyre wear, or an ABS/traction warning if the integrated tone feature is affected.

Do you need a wheel alignment after replacing a Camry wheel bearing?

Usually no, because the hub bolts on without altering suspension geometry. However, get an alignment check if any strut or control arm bolts were loosened, or if there’s existing uneven tyre wear or a steering pull.

A quick post-repair check also helps confirm everything is straight after any impact that might have caused the bearing issue in the first place.