Your Selected Vehicle
Parts for your 2022 Mitsubishi Outlander-Brake pad wear indicator
Explore 4WD & Adventure
2022 Mitsubishi Outlander brake pad wear indicator
Based on Mitsubishi Motors technical literature for the 2022 Outlander (Owner’s Manual – Brakes section, Service Manual – Front and Rear Disc Brakes) and the Mitsubishi Genuine Parts catalogue listings for pad kits with built‑in wear indicators, this model uses mechanical brake pad wear indicators (commonly called squeal tabs) on the pads. There isn’t an electronic pad‑wear warning lamp on the dash, instead, the indicator makes a high‑pitched squeal when the pad is near the end of its service life, backed up by regular visual inspections during scheduled servicing.
The brake pad wear indicator’s job is simple but important: it gives a clear, audible heads‑up that the pad friction material is running low. As the pad thins to a set threshold, the metal tab just kisses the rotor and chirps. That sound means it’s time to plan a pad change before the friction material is gone, protecting the rotor from damage and keeping braking performance consistent and safe for day‑to‑day Kiwi and Aussie driving.
For servicing a 2022 Outlander, the indicator is treated as part of the pad set. When pads are replaced, the indicator comes already attached to one of the pads in each caliper. The technician should note pad orientation so the indicator sits in the correct position relative to rotor rotation, clean and lubricate the slide pins with appropriate high‑temp brake grease, and refit the anti‑rattle shims. If an indicator tab is bent, cracked or missing, don’t try to “straighten and reuse” it—replace the pad set. After installation, follow the bedding‑in procedure recommended in the service information: a series of gentle stops from moderate speed, avoiding hard braking for the first couple of hundred kilometres so the new pads and rotors mate properly.
- Listen for persistent, high‑pitched squeal that changes when the brakes are applied—classic wear‑indicator noise.
- Inspect pad thickness at every service or tyre rotation, replace when near the service limit or if the indicator is contacting.
- Never remove an indicator to silence a squeal, that defeats the safety feature.
- Check both inner and outer pads—wear rates can differ.
- Torque caliper hardware to the service manual spec and ensure slides move freely.
Technical sources: Mitsubishi Motors 2022 Outlander Owner’s Manual (Brakes), Mitsubishi Motors Service Manual for 2022 Outlander – Front/Rear Disc Brakes (Pad with Wear Indicator), Mitsubishi Genuine Parts/ASA catalogue listings for pad kits with wear indicator.
Popular questions
Does the 2022 Outlander have a dashboard light for pad wear?
No. The factory setup uses mechanical wear indicators (squeal tabs) on the pads rather than an electronic sensor and warning lamp. The warning you’ll notice is the audible squeal plus the pad thickness check during routine servicing.
How often should the brake pad wear indicator be checked?
It’s checked whenever the pads are inspected—typically at every service or tyre rotation. If you’re hearing a consistent squeal that goes away under light braking, book in for a pad inspection soon, as the indicator may be contacting the rotor.
Can the indicator tab be replaced on its own?
No. On the 2022 Outlander the indicator is part of the pad. If it’s worn to the point of contact, damaged, or missing, the correct fix is to replace the pad set on that axle so braking stays balanced and quiet.
