Parts for your 2022 Mitsubishi Eclipse cross-Tail lights

2022 Mitsubishi Eclipse Cross Tail-lights: Purpose, Care and Replacement

Tail-lights are absolutely fitted and relevant on the 2022 Mitsubishi Eclipse Cross. The model uses rear combination lamps that provide tail (rear position), stop, indicator and reverse functions, with LEDs on most trims. This is confirmed by Mitsubishi’s 2022 Eclipse Cross owner’s/service literature for rear combination lamps, and by compliance with Australian Design Rules for lighting (ADR 13/00 and ADR 49/00) as well as UN ECE Regulations R7 and R48. NZ road rules administered by Waka Kotahi also require two red rear position lamps. So yes—this vehicle relies on its tail-lights for legality, safety and visibility.

On the 2022 Eclipse Cross, the tail-lights make the vehicle visible from behind at night and in bad weather, and work alongside the brighter brake lamps to signal slowing or stopping. Many variants use LED elements that switch on with the headlamps or when the auto-light function decides it’s dark enough. Drivers sometimes mistake daytime running lights for headlights, that can leave the rear dark. It’s worth checking that the tail-lights are actually on whenever conditions are gloomy.

As part of routine servicing, a quick tail-light check pays off. LEDs generally last longer than bulbs, but they’re not immune to damage from moisture, impacts or wiring faults. Some trims may still use conventional bulbs for certain rear functions, so always confirm the fitment in the owner’s manual before buying parts.

• Walk-around test: switch lights on, press the brake, indicate left/right, select reverse, and confirm the lot.
• Keep lenses clean: wash road grime off and avoid harsh solvents that can haze plastic.
• Look for cracks or condensation: moisture inside the lens points to a failing seal.
• Check fuses and wiring if a lamp won’t light, the fuse map is in the fuse-box cover and handbook.

If a lamp or LED segment has failed, many Eclipse Cross variants require replacing the whole rear combination assembly rather than a single LED. Replacement is straightforward: open the tailgate, remove the interior access trim, undo retaining fasteners, ease the lamp straight back to release the clips, disconnect the harness, then refit in reverse. If a bulb-type holder is fitted on your variant, twist out the holder and install a like-for-like globe to the specified wattage—avoid touching the glass with bare fingers. Use genuine or OEM-quality parts to maintain brightness and beam pattern, and have the work checked for water-tightness once done.

Popular questions

Are the 2022 Eclipse Cross tail-lights LED?
Most Australian and New Zealand 2022 Eclipse Cross variants use LED rear combination lamps for tail and stop functions. Some trims may still use conventional bulbs for indicators or reverse. The owner’s manual lists the exact setup for the specific grade.

Can individual bulbs be replaced, or is it a full assembly?
If the function is LED, it’s typically a sealed module and the whole lamp assembly is replaced. If a conventional globe is used on the variant, that globe can be replaced individually. Always check the lamp label or the handbook before ordering parts.

Is it legal to drive with a tail-light out in AU/NZ?
No. Both ADRs and NZ road rules require working rear position lamps. Driving with a failed tail-light risks a fine and, more importantly, makes the vehicle harder to see at night or in rain. It should be fixed straight away.