Your Selected Vehicle
Parts for your 2021 Mitsubishi Asx-Pedal pads
Explore 4WD & Adventure
Product added to cart
2021 Mitsubishi ASX pedal pads
Pedal pads are fitted to the 2021 Mitsubishi ASX. Technical references that confirm this include Mitsubishi Motors’ workshop/service information and the OEM electronic parts catalogue (often referred to as ASA/CAPS), which show a replaceable rubber pad on the brake pedal, and on the clutch pedal for manual models. The accelerator pedal on the ASX is an integrated moulded assembly and typically doesn’t use a separate rubber pad.
On this ASX, the pedal pad’s job is simple but vital: provide a grippy, non-slip surface so the driver’s shoe stays planted in the wet, in dusty conditions, or after a long day in boots. The brake (and clutch, if fitted) pad is a thick rubber cover that wraps around the metal pedal plate, cushioning the foot and maintaining consistent friction. That grip is part of good roadworthiness, and it’s why the factory design uses durable rubber with grooves that shed water and grit.
As part of routine servicing, it makes sense to have the pedal pads inspected. In Aussie and Kiwi conditions, with beach trips, red dust or winter mud, rubber can harden or glaze. At each service interval (about every 12 months/15,000 km), a quick check for cracking, smooth shiny spots or edges lifting is worthwhile. Keep them clean by wiping with mild soapy water, avoid silicone or oily dressings, which can turn the pad slippery.
- Replace the pad if it’s cracked, hardened, polished smooth, torn, or if the lip no longer sits firmly around the metal pedal.
- If the pedal gets contaminated with oil/grease, clean or replace immediately.
Swapping a worn brake pedal pad is a simple job. Use a genuine pad matched to the ASX to retain the correct fit and grip. Warm the new pad slightly to make it more pliable, then:
- Pull the old pad off the pedal plate and clean the metal surface.
- Hook the new pad over the top edge of the plate.
- Work the rubber lip around the sides and bottom until it’s fully seated with no twists.
Most owners can do this in a few minutes, or a workshop can handle it during a service. Steer clear of flashy alloy clip-on covers that can reduce traction and may fall foul of WOF/RWC inspections. A fresh, grippy OEM-style pad helps keep braking feel consistent and safe, day in and day out.
Popular questions
Does the 2021 Mitsubishi ASX have pedal pads?
Yes. The brake pedal has a replaceable rubber pad, and manual versions also have a clutch pedal pad. The accelerator is usually an integral pedal without a separate pad.
When should the brake pedal pad be replaced?
Replace it when it’s cracked, hardened, smooth or lifting at the edges. It’s smart to check at every service or at least yearly, especially if you drive in wet, sandy or muddy conditions.
Can aftermarket alloy pedal covers be used?
They’re not recommended. Some reduce grip, can loosen, and may impact WOF/RWC compliance. A genuine or OEM-equivalent rubber pad keeps the right feel and traction.
Popular Searches
