Parts for your 2020 Toyota Land cruiser-Tail lights

2020 Toyota Land Cruiser tail-lights

Tail-lights are absolutely fitted to the 2020 Toyota Land Cruiser (200 Series) and are mandatory for road use. This is supported by the Toyota Owner’s Manual and Toyota workshop literature for the 200 Series, as well as Australian Design Rules ADR 13/00 (Installation of lighting) and ADR 49/00 (Front and rear position lamps, stop lamps and rear registration plate lamps). New Zealand’s Land Transport Rule: Vehicle Lighting 2004 also requires rear position lamps on passenger vehicles. So, yes—tail-lights are relevant, standard, and legally required on this model.

On a 2020 Land Cruiser, the tail-lights form part of the rear combination lamps. Their main jobs are: rear position lighting so other drivers see the vehicle at night or in low light, brake signalling, turn indication, reverse lighting, and, depending on market/grade, a rear fog function. Many Aussie and Kiwi 200 Series variants use LED tail/stop lamps for long life and consistent brightness, while indicators and reverse lamps may be conventional bulbs on some grades.

For everyday motoring, keeping the Land Cruiser’s tail-lights in top nick is simple and worth it. They’re crucial for visibility when towing, touring out bush, or tackling wet winter commutes.

• Check operation at least monthly and at every service: tail, brake, indicators, reverse, and number-plate lamps.
• If fitted with LEDs, you won’t be replacing “bulbs” for tail/stop, the module or lamp assembly is replaced if it fails.
• For bulb-equipped functions, use the exact type listed in the owner’s manual and avoid touching glass with bare hands.
• Inspect lens condition—cracks, water ingress, or faded lenses reduce light output and can attract a defect notice.
• Confirm trailer wiring hasn’t introduced faults, poor earths and scotch-locks are common culprits.

Basic replacement notes (guide only): open the split tailgate, remove the inner access trim, undo the lamp retaining screws/bolts, then slide the lamp rearwards to release the locator pins. Disconnect the harness plug, swap the bulb or lamp as needed, and refit carefully to avoid damaging clips. Always test all functions before hitting the road.

If a lamp is intermittently dim or out, check the fuse, connector pins for corrosion, and the earth point. With LEDs, a full lamp replacement is usually the fix. Given the Land Cruiser’s frequent towing and off-road use, a quick light check before trips is smart practice.

Are the 2020 Land Cruiser tail-lights LED?
Many 200 Series grades in 2020 use LED tail/stop lamps, with indicators and reverse lamps sometimes using conventional bulbs. Check the owner’s manual and the lamp markings for your exact grade. If the tail/stop are LED and fail, the usual remedy is replacing the lamp assembly rather than a bulb.

What causes tail-lights to stop working on a 200 Series?
Common causes include blown bulbs (for non-LED functions), a failed LED module within the assembly, a poor earth, moisture in the housing, or a blown fuse—sometimes triggered by trailer wiring. Inspect connectors and seals, and test the circuit with a multimeter if faults persist.

Can I drive with one tail-light out in Australia or New Zealand?
It’s not recommended and may be illegal. Road rules require working rear position and stop lamps. Driving with a failed lamp risks a fine or defect notice and reduces visibility to others, especially at night or in heavy rain. Fix it before you travel.