Parts for your 2020 Haval H6-Wheel bearings

2020 Haval H6 Wheel Bearings — what they do and when to replace them

Wheel bearings are absolutely used on the 2020 Haval H6. Technical sources such as the Haval H6 Workshop Manual (Front/Rear Hub &, Bearing Assembly sections) and major bearing catalogues (SKF, NTN, Timken listings for 2017–2020 H6) confirm the vehicle runs sealed, unitised hub-bearing assemblies at each corner. So yes—wheel bearings are very much relevant on this model.

On the H6, the wheel bearings carry the vehicle’s weight, let the wheels spin smoothly with minimal friction, and help keep everything tracking straight. They also work hand-in-hand with ABS/ESC via an integrated encoder, feeding clean signals so the safety systems behave as they should. Because they’re sealed hub units, there’s no greasing or adjustment, when they wear out, the whole hub assembly is replaced.

What drivers tend to notice when a bearing starts to go is noise and play. Common signs include:

• A humming or growling that rises with road speed, often louder when turning one way
• ABS/ESC warning light triggered by a dodgy encoder signal
• Uneven tyre wear, heat at the hub, or detectable free play at 12 and 6 o’clock

For servicing, think inspection rather than maintenance. A quick spin-and-listen during brake or tyre work, plus a feel for roughness and play, is ideal every 10–15,000 km. Aussie and Kiwi roads—corrugations, water crossings, and plenty of urban stop-start—can speed up wear, so regular checks pay off.

When it’s time to replace, it’s a bolt-off/bolt-on job for the complete hub unit. Good practice includes:

• Use quality OE-equivalent hubs with the correct ABS encoder polarity
• Clean the knuckle and hub faces so the new unit sits square and true
• Torque the axle nut and hub bolts to spec with a torque wrench—don’t rattle them up with a rattle gun
• Road test and confirm ABS/ESC operation, alignment isn’t usually required, but check if the knuckle was disturbed

How long do they last? Many go 100,000–200,000 km, but heavy loads, big wheels, and rough surfaces can shorten that. Replacing only the noisy side is fine once it’s diagnosed, though at high kilometres some owners choose to do both on the same axle for peace of mind.

Popular questions

How long do wheel bearings last on a 2020 Haval H6?
Many owners see 100,000–200,000 km from factory bearings. Driving on coarse-chip, corrugated, or flooded roads, towing, and running larger wheels can bring that forward. Regular inspections during brake and tyre services help catch issues early.

Can H6 wheel bearings be greased or adjusted?
No. The 2020 H6 uses sealed, unitised hub assemblies. There’s no adjustment and no way to repack grease. If a bearing is noisy, rough, or loose, the complete hub unit is replaced.

Do both front (or rear) bearings need replacing together?
Not necessarily. Replace the confirmed faulty side. If the vehicle has high kilometres or both sides show similar wear, doing them as a pair can save a second visit. A wheel alignment isn’t typically needed unless suspension geometry was disturbed.