Your Selected Vehicle
Parts for your 2020 Ford Fiesta-Headlight bulbs
Explore 4WD & Adventure
LED Autolamps 12/24V Stop/Tail/Indicator Light Clear Lens Coloured LEDs Surface Mount - 12ARM-2
LED Autolamps 12/24V LED Amber Emergency Light Flash Patterns With Sync Wire Blister Pack - 120035AM
LED Autolamps 12V Indicator Strip Lamp With 10 Square LEDs Recessed Mount - 235A12
LED Autolamps 12V Stop/Tail Strip Lamp With 10 Square LEDs Recessed Mount - 235R12
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Diffused Tail Light - 284ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator/Licence Plate Lamp with Reflex Reflector - 99ARL
LED Autolamps Multi Volt Stop/Tail/Ind/Rev With Try Me Function Diffused Tail With Sequential Indicator Twin Blister - 385ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator Light With Reflex Reflector Twin Blister - 100BAR2
LED Autolamps 12V LED Stop/Tail/Indicator Lamps With Reflector Twin Blister - 101BAR2
2020 Ford Fiesta headlight-bulbs — are they used on this model?
Based on Ford’s technical literature for Australia and New Zealand, conventional headlight-bulbs are not used for the 2020 Ford Fiesta that was officially sold in these markets (the Fiesta ST). The Ford Australia/NZ model specification lists LED headlamps with auto high-beam, and the corresponding Owner’s Manual notes the headlamp light source is a non-serviceable LED module that requires replacement of the complete lamp unit if it fails. Workshop information for the Mk8 Fiesta backs this up, detailing headlamp assembly replacement rather than bulb swaps for LED-equipped cars.
Why no headlight-bulbs? Ford integrated LED modules deliver a brighter, cleaner beam pattern, reduced power draw, and better durability than halogen bulbs. The LED projectors are sealed to protect against moisture and dust, and to maintain precise optical alignment that meets ADR/ECE lighting standards. Because the LED chip and heat sink are built into the assembly, there’s no separate low- or high-beam bulb to replace.
- Performance: Crisp cutoff and strong down-road illumination from the factory LED projector.
- Efficiency: Lower current draw helps overall electrical efficiency.
- Durability: Solid-state LEDs typically outlast halogen bulbs and handle vibration better.
Servicing tips for a 2020 Fiesta with LED headlamps are a bit different to a bulb-type setup. If a headlight looks dim, flickers, or drops out, start with simple checks: clean the outer lens with a pH-neutral wash, make sure there’s no heavy hazing or yellowing, and confirm the relevant fuses and connectors are sound. If the fault persists, a technician should scan for body control module faults and verify power and earth at the headlamp connector. Where an LED module has failed, the approved fix is to replace the headlamp assembly with a genuine, ADR-compliant unit and then check beam aim.
Note: In some overseas markets, certain 2020 Fiesta trims used halogen headlight-bulbs (commonly H7 low beam with a separate high beam). Those bulb types don’t apply to the 2020 AU/NZ lineup, which is why “headlight-bulbs” aren’t relevant for this vehicle locally.
Does the 2020 Ford Fiesta in Australia or New Zealand have replaceable headlight-bulbs?
No. The 2020 AU/NZ Fiesta (ST) uses integrated LED headlamps for low and high beam. There are no conventional headlight-bulbs to swap. If the light source fails, the complete headlamp assembly is replaced.
What should be checked before replacing a 2020 Fiesta LED headlamp assembly?
Clean the lens, confirm the correct fuses and relays, inspect the wiring and connectors for corrosion, and have a technician scan the body control module. If power and earth are good and there’s still no output, the LED unit is likely faulty and the full assembly should be replaced.
Can halogen or aftermarket LED bulbs be fitted to the 2020 Fiesta headlamps?
Not recommended. The AU/NZ 2020 Fiesta’s LED headlamp is a sealed, homologated unit. Swapping in bulbs or non-genuine assemblies can affect beam pattern and ADR compliance, and may cause glare or inspection issues. Use genuine, like-for-like headlamp assemblies.