Parts for your 2019 Ford Everest-Gas struts

2019 Ford Everest gas struts — what they do and when to replace them

Gas struts are fitted to the 2019 Ford Everest. Technical sources that reference these include the Ford Everest Owner’s Manual (Power Liftgate section), the Ford Workshop Manual section 501-03 Body Closures and Security (liftgate strut removal/installation), and OEM/aftermarket parts catalogues that list dedicated tailgate/liftgate support struts for 2015–2022 Everest models. Even vehicles with a powered tailgate still rely on gas-charged struts to balance the weight of the liftgate.

On a 2019 Ford Everest, gas struts take the grunt out of lifting the heavy tailgate and keep it securely held at full height. They also help the powered tailgate operate smoothly by counterbalancing the mass, so the motor isn’t doing all the hard work. Some Everest variants may also use gas struts on the bonnet, where a prop rod is fitted, the bonnet has no struts. Either way, the job of a gas strut is simple: assist lift, control motion, and hold the panel safely open.

As part of routine servicing, it’s smart to check the gas struts every 12 months. A quick once-over goes a long way: look for oil weeping at the rod seal, listen for creaks, and note any slow opening, sagging, or bouncing near the top of travel—especially on cold mornings, when weak struts show up fastest. Keep the chrome rod clean and dry, but don’t lubricate it, oils and greases can damage the seals.

• Replace in pairs to keep lift and holding force even.
• Support the tailgate with a prop or helper before unclipping the old struts.
• Use struts with the correct Newton (N) rating for the Everest’s tailgate and any accessories fitted.
• If equipped with a power tailgate, cycle it fully a few times after replacement to let the system relearn end points.

Most Everest gas struts last four to eight years, depending on climate and use. If the tailgate won’t stay up, stops short of full height, or slams shut in wind, it’s time. The swap is a straightforward job: pop the retaining clips, lever the old strut off the ball studs, and click the new ones on. Torque any fasteners to spec if your variant uses bolted ends. Using quality OE-equivalent units (common suppliers include Stabilus and Monroe in catalogues for this model) keeps the lift smooth and the power tailgate happy, saving the motor and hinges from extra strain.

FAQs

How long do 2019 Ford Everest gas struts typically last?
In normal Aussie and Kiwi conditions, expect roughly four to eight years. Lots of tailgate cycles, roof loads, dust, or heat can shorten that. If the tailgate sags, needs a shove to start moving, or won’t hold at full height, the struts are due.

Can gas struts on a power tailgate be replaced at home?
Yes, provided the tailgate is safely supported. Replace both sides, avoid twisting the ball studs, and don’t grease the rods. After fitting, open and close the powered tailgate a few times to settle the control module. If it struggles or beeps errors, check the strut rating matches the vehicle.

What spec gas struts does the Everest need?
Struts are rated in Newtons and vary by model year, trim and whether a power tailgate is fitted. The safest way is to match by VIN using an OEM or reputable aftermarket catalogue. Avoid “universal” units—wrong force can upset the power tailgate and hinge alignment.