Parts for your 2017 Toyota Vitz|yaris-Pedal pads

2017 Toyota Vitz/Yaris pedal pads

Based on Toyota’s technical literature, pedal pads are definitely fitted to the 2017 Toyota Vitz/Yaris. The Toyota Electronic Parts Catalogue (EPC) for the XP130-series (e.g., NSP130/NCP131/KSP130) lists a serviceable “Pad, Brake Pedal”, and manual-transmission variants also show a “Pad, Clutch Pedal”. The model family’s owner’s manual references checking the brake pedal rubber pad for wear, and the factory repair manual includes removal/installation steps for the pad. That confirms pedal pads are relevant to this vehicle.

On a 2017 Vitz/Yaris, the brake pedal uses a grippy rubber pad, and manual models add a clutch pedal pad. Their job is simple but important: provide secure foot traction, reduce vibration, and keep pedal dimensions compliant with regulations. The accelerator pedal on this model is an integrated module with a textured plastic face and doesn’t use a separate rubber pad.

Because these pads live underfoot, they cop plenty of abuse from sand, mud, wet boots and summer heat across Australia and New Zealand. Over time the rubber can harden, glaze, crack or peel at the edges. If the pad’s surface goes shiny or smooth, or it feels slippery when wet, it’s time to replace it. During regular servicing, it’s smart to include a quick pedal pad check along with floor mat security and pedal free movement.

Replacement is straightforward and inexpensive. Use a genuine or quality-equivalent pad so the fit is snug around the steel pedal plate. The old pad is pried off, the new pad is worked over the pedal starting with the lower lip, then stretching the upper lip into place. After fitting, press the pedal through its full travel to confirm there’s no fouling and that the pad is fully seated on all sides.

To keep pedal pads in good nick:

• Clean with mild soap and water, avoid silicone dressings or greasy cleaners that make them slippery.
• Ensure floor mats are clipped in correctly and never stacked—loose mats can ride up and interfere with pedals.
• Inspect at each service or at least every 10,000–15,000 km. Replace immediately if torn, loose, or smooth.

Signs it’s time to replace:

• Shiny, slick or hardened surface
• Cracks, chunks missing, or pad lifting at the corners
• Foot slips more easily in the wet

Keeping fresh, grippy pedal pads is a small job that pays off in everyday confidence behind the wheel.

Popular questions about 2017 Toyota Vitz/Yaris pedal pads

Does the accelerator have a replaceable pedal pad?
The accelerator on the 2017 Vitz/Yaris is a one-piece electronic pedal with a moulded, textured face—there’s no separate rubber pad to replace. Only the brake (and the clutch on manuals) uses a replaceable pedal pad.

How often should brake and clutch pedal pads be replaced?
There’s no fixed interval. Inspect them at every service. In typical Aussie and Kiwi conditions they often last years, but replace straight away if the rubber is smooth, cracked, hard, loose or slippery—especially if you drive in wet, sandy or muddy conditions.

Can alloy pedal covers be fitted?
They can, but they must be secure, non-slip and must not reduce pedal control. Make sure they don’t foul the pedal travel or floor mats, and that they meet local roadworthy/WOF expectations. For daily use, OEM-style rubber pads generally offer the best wet-grip feel.