Parts for your 2017 Suzuki Splash-Clutch kit

2017 Suzuki Splash clutch kit — what it does and when to replace it

Based on Suzuki’s factory workshop information for the Splash/Ritz (K10B/K12B) and widely used technical databases such as Autodata/HaynesPro and Suzuki’s Electronic Parts Catalogue, the Splash fitted with the 5‑speed manual transmission uses a conventional dry single‑plate clutch assembly. That means a clutch kit is relevant to a 2017‑registered Splash if it’s a manual. Automatic (4‑speed) variants use a torque converter, so a clutch kit doesn’t apply to those.

On a manual 2017 Suzuki Splash, a clutch kit bundles the friction disc, pressure plate (cover) and release/throw‑out bearing, and is designed to restore smooth take‑up and crisp gear changes. Over time, the friction material thins, the pressure plate loses clamping force, and the bearing can get noisy. Swapping the lot as a matched kit saves mucking about and usually outlasts piecemeal fixes.

Drivers will typically notice tell‑tales like slip under load, a high bite point, shudder on take‑off, or a crunchy shift into first and reverse. A heavy or inconsistent pedal can point to wear in the release mechanism. If the vehicle uses a hydraulic actuator, any fluid leaks or spongy feel are also red flags.

There’s no fixed service interval for a clutch — life can range from roughly 80,000 to 160,000 kilometres, depending on how it’s driven. Lots of hill starts, towing a small trailer, stop‑start city traffic, and riding the clutch will all shorten its life. Gentle take‑offs and selecting neutral at long lights help it go the distance.

When replacement time rolls around, it’s smart practice to install the full kit and inspect the flywheel. If it’s heat‑spotted or scored, have it machined or replace it. It’s also a good moment to check the rear main seal, gearbox input shaft seal, and driveshaft seals, and to refresh the gearbox oil. Follow the Suzuki torque specs and alignment procedure in the workshop manual — new bolts may be specified for the cover.

After fitting, a short bedding‑in period (a few hundred kilometres of smooth, light‑throttle driving) helps the new friction surfaces settle. For parts, stick with OEM or a reputable brand matched to the Splash/Ritz manual gearbox. Even though the Splash’s main production ended earlier, many 2017 cars are late registrations — the clutch hardware remains the same as the corresponding manual model years.

• Watch for slip or shudder under load
• Avoid riding the pedal