Parts for your 2017 Nissan Serena-Coil springs

2017 Nissan Serena Coil Springs

Based on Nissan C27 Serena service documentation and reputable parts catalogues, the 2017 Nissan Serena is fitted with coil springs at both ends—MacPherson strut front and torsion beam rear—so coil springs are absolutely relevant for this model.

On the Serena, the coil springs do the heavy lifting: they support vehicle weight, set ride height, and let the dampers (shocks/struts) control bounce. That’s why the van feels composed over speed humps, corrugations and motorway joins, even with the family on board. Healthy coils keep the tyres in contact with the road, help braking stability, and protect the rest of the suspension from harsh hits.

They’re tough, but not invincible. Road grime, coastal air, and repeated heavy loads can chip the paint and start corrosion. Over time, a spring can sag or even crack—especially at the “pigtail” ends. It pays to have them inspected during routine servicing, ideally every 20,000 km or annually, and sooner if the van tows or carries big loads regularly.

• Signs it’s time to act: droopy ride height on one corner, uneven tyre wear, clunks over bumps, a harsher or floaty ride, or visible rust and broken coils.
• Quick driveway checks: park on level ground and eyeball the gap above each tyre, look for chipped coating or rust, listen for knocks on speed humps.

When replacing, do both fronts or both rears as a pair to keep the van level and predictable. Always choose springs that match the Serena’s exact variant (including hybrid/e-Power or seat configuration) so the rate and free length are right. It’s smart to renew struts/shocks, top mounts, insulators and bump stops at the same time—then finish with a wheel alignment to lock in proper handling and tyre life.

• Workshop tips owners should expect: compress springs with the correct tool (they store a lot of energy), torque fasteners at normal ride height, and verify ride height after a short road test.
• To extend spring life: rinse off road salt and beach sand, avoid chronic overloading, and fix leaking shocks quickly—they hammer the coils if ignored.

Popular questions

Does the 2017 Nissan Serena use coil springs or another type?
Yes—coil springs front and rear. The front uses a MacPherson strut with a coil and the rear uses a torsion beam with coil springs, giving a comfortable, controlled ride for family duties.

How often should Serena coil springs be replaced?
There’s no fixed interval. Replace when sagged, cracked or broken, or if ride height and handling are off. A good rule is to have them inspected at each service or about every 20,000 km, and sooner if the van carries heavy loads or tows.

Can lowering springs be fitted safely to a Serena?
They can, but only when matched to suitable dampers and followed by an alignment. Expect a firmer ride and check local rules and insurance—compliance and certification may be required in AU/NZ.