Parts for your 2017 Audi Q5-Coil springs

2017 Audi Q5 coil springs — what they do and how to look after them

Coil springs are absolutely relevant to the 2017 Audi Q5 (Type 8R). The model uses steel coil springs on both the front five‑link axle and the rear trapezoidal‑link axle. This is documented in Audi Self‑Study Programme 434 “The Audi Q5,” the Audi Q5 (8R) Workshop Manual (Repair Groups 40 Rear Suspension and 42 Front Suspension), and the Audi ETKA factory parts catalogue for model 8R, which lists multiple PR‑code coil spring options. Major suspension suppliers also catalogue replacement springs for the 2008–2017 Q5 8R, reinforcing that the vehicle is coil‑spring equipped.

On a 2017 Q5, the coil springs carry vehicle weight, set ride height, and keep the tyres planted over bumps while the dampers control the bounce. They work hard with every kilometre, so a bit of sag or corrosion over time is normal, especially with towing, roof loads, or rough Kiwi and Aussie roads.

What owners notice when springs are tired or broken: a droopy corner, clunks over speed humps, floaty body control, uneven tyre wear, or a visible chip/crack near the spring end. If any of that shows up, it’s time for an inspection.

Replacement and servicing tips for a 2017 Audi Q5 coil spring setup:

• Always replace in axle pairs to keep handling even.
• Match the exact PR‑code/paint marks so the spring rate suits the vehicle’s spec (engine, options, tow package).
• Use proper spring compressors and support points, the Q5 front is a coil‑over strut, rear spring is separate from the damper.
• Renew related wear items while you’re there: strut mounts/bearings, bump stops, and dust boots.
• Tighten suspension bolts at normal ride height and book a wheel alignment after the job.

There’s no fixed replacement interval—springs are condition‑based. A good rule is to inspect them at every service (or at least every 15,000 km), paying attention to corrosion, chipped coating, and ride height. Many Q5s are fine well past 120,000–160,000 km, but coastal environments and heavy loads can shorten that.

Technical references: Audi Self‑Study Programme 434 “The Audi Q5”, Audi Q5 (8R) Workshop Manual, Repair Groups 40/42, Audi ETKA parts catalogue for 8R front/rear coil springs, Eibach/H&R application guides for Audi Q5 8R 2008–2017.

Popular questions about 2017 Audi Q5 coil springs

Does the 2017 Audi Q5 have air suspension or coil springs?
The 2017 Q5 (8R) runs steel coil springs front and rear across the range. Some later‑generation Q5 models offered optional air suspension in certain markets, but the 2017 8R does not. Adaptive dampers may be fitted, but they work with the same coil springs.

How long do the coil springs last on a 2017 Q5?
There’s no fixed lifespan. Many last beyond 120,000–160,000 km, but regular checks are wise. Replace if there’s a broken coil, significant corrosion, sagging ride height, or poor handling. If one spring fails, replace both on that axle.

Can just one coil spring be replaced?
It’s strongly recommended to replace coil springs in pairs on the same axle to maintain balanced ride height and handling. Always match the spring to the vehicle’s PR‑code to get the correct rate and height.