Your Selected Vehicle
Parts for your 2017 Audi Q5-Batteries
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Lamp 460x130x33mm - 460ARWM
LED Autolamps 12/24V Reverse Lamp Horizontal/Vertical Mount Twin Blister - 11WM-2
LED Autolamps 12V Stop/Tail/Indicator/Licence Plate Lamp With Reflector - 149BARL4P
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp With Reflex Reflectors Grey Base Blister Pack 1 pce - 100ARM
Explore 4WD & Adventure
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
LED Autolamps 12V Stop/Tail Lamp Black Chrome Round With Clear Lens - 102RBC
LED Autolamps 12/24V Reversing Lamp With 25 White LEDs With Bracket and 30cm Wire - 100WM
LED Autolamps 10/30V LED Side Direction Indicator Light With 30cm Wire - 35AMB
LED Autolamps 12V 82 Series Stop/Tail/Indicator/Reverse Lamp Black Bracket - 82BARW
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps 12/24V LED Reverse Lamp Screw Surface Mount Blister Pack - 12WM-2
LED Autolamps Multi Volt Stop/Tail/Indicator With 18 Square LEDs Twin Blister - 135ARM/2
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
2017 Audi Q5 — Batteries
Yes, the 2017 Audi Q5 is fitted with a 12‑volt battery and it’s essential to how the vehicle operates. Audi owner’s literature for the model year and Audi technical service information for the Q5 platform note an intelligent Battery Energy Management system and, on Start/Stop‑equipped variants, specification of an AGM (Absorbent Glass Mat) battery. Those same technical sources advise that battery details are registered (coded) to the vehicle after replacement so the charging strategy stays accurate.
In a 2017 Q5, the battery’s job is bigger than just starting the engine. It powers safety systems, infotainment, lighting, convenience features, and supports Start/Stop where fitted. The Q5 continuously monitors state of charge and temperature to protect the battery and keep the car reliable, which is why matching the correct battery type and capacity matters.
For servicing, a quality AGM or EFB battery (as specified by the build and equipment level) should be used. After installation, the battery must be registered to the energy management module with a compatible scan tool so the alternator output, Start/Stop logic, and load shedding behave properly. Skipping this step can shorten battery life or leave Start/Stop unavailable.
Good ownership habits go a long way in Australia and New Zealand conditions:
- Have the battery load‑tested annually from year three, or before long trips.
- If the Q5 is mainly doing short runs, give it a periodic long drive or use a smart maintenance charger set to the correct battery chemistry.
- Keep terminals clean and tight, corrosion introduces voltage drop that upsets modules.
- When changing the battery, preserve vehicle memory where practical and follow safe jump‑start/charging points under the bonnet as shown in the owner’s manual.
Common signs it’s due for replacement include slow cranking, Start/Stop being frequently unavailable, warning messages about electrical consumers, or intermittent electronic gremlins after the car has sat. Typical lifespan is 4–6 years, but high heat, short trips, and added accessories can shorten that window. Choosing a like‑for‑like replacement (type and capacity), and ensuring the battery is coded, keeps the Q5 starting first time and its clever energy systems happy.
Popular questions about 2017 Audi Q5 batteries
What type of battery does a 2017 Audi Q5 use?
Most 2017 Q5 variants specify an AGM 12‑volt battery, especially where Start/Stop is fitted. The exact capacity and case size vary by engine and equipment. Matching the original amp‑hour rating and chemistry is important so the Battery Energy Management system can charge it correctly.
Does the battery need coding after replacement?
Yes. The Q5’s energy management expects the correct battery type, capacity, and serial data. Registering (coding) the new battery with a suitable scan tool helps avoid under/overcharging, protects the new battery, and keeps Start/Stop and alternator control working as intended.
How long should the battery last?
In Aussie and Kiwi conditions, 4–6 years is common. Lots of short trips, high accessory loads, or extreme heat can shorten life. From year three, have it tested at each service and before road trips to avoid surprises.