Parts for your 2016 Volkswagen Amarok-Exhaust mount

2016 Volkswagen Amarok Exhaust Mount — Purpose, Fitment and Service Advice

Yes, the 2016 Volkswagen Amarok is fitted with exhaust mounts (also called exhaust hangers). This is confirmed by Volkswagen’s Amarok (2H) workshop manual sections covering exhaust removal/installation and mounting hardware, and by the Volkswagen ETKA parts catalogue, which lists multiple rubber mounting hangers and brackets for the Amarok exhaust system. Major aftermarket catalogues for Australia and New Zealand also list Amarok-specific exhaust mounts, further validating their use on this ute.

On the Amarok, the exhaust mounts are tough rubber isolators that suspend the exhaust system from the chassis. Their job is to keep the pipework and mufflers correctly aligned while absorbing vibration, so the cabin stays quiet and the exhaust doesn’t knock on the body, crossmembers or towbar. Over time, heat, road grime and load from towing or corrugations can harden or crack the rubber, leading to rattles, thumps, or a sagging tailpipe.

As part of routine servicing, it’s smart to check the exhaust mounts at each service interval (or at least every 15,000 km). Look for perishing, splits, elongation of the holes, or excessive movement of the exhaust when it’s gently rocked by hand. If any mount looks tired, replace it in pairs around the affected section to keep alignment true. According to Volkswagen workshop procedures, the exhaust should always be safely supported before removing any mount, and brackets/clamps should be rechecked to factory torque once new mounts are in.

• Common symptoms of worn mounts on an Amarok:
  • Rattle or knocking over bumps or at idle
  • Exhaust sitting low or skewed in the bumper cut-out
  • Vibration transmitted into the cabin or tray
• Replacement tips:
  • Use a little silicone spray to slide mounts on/off the pegs
  • Inspect nearby brackets for cracks or loose hardware
  • Choose OE-quality rubber for best NVH, stiffer polyurethane can suit heavy towing/off-road but may increase vibration

Technical basis: Volkswagen Amarok (2H) Workshop Manual procedures for exhaust system mounting, Volkswagen ETKA parts catalogue listings for Amarok exhaust mounting rubbers/hangers, reputable aftermarket catalogues supplying Amarok-specific exhaust mount components.

How do you know the exhaust mounts on a 2016 Amarok need replacing?

Tell-tales include a metallic rattle or thud over bumps, a tailpipe that sits off-centre or lower than normal, or a buzz through the cabin at certain revs. A quick visual check will often reveal cracked, perished, or stretched rubber.

With the ute safely lifted and the exhaust supported, gently rock the system. Excessive movement at any hanger point usually means that mount is done.

Are polyurethane exhaust mounts a good idea for towing or off-road use?

They can be, because stiffer mounts better control exhaust movement under load and over rough tracks. The trade-off is a touch more vibration transmitted into the body. For everyday road use and best comfort, OE-style rubber is the safer bet, for heavy towing and corrugations, quality polyurethane can be worthwhile.

Can this job be done at home?

Yes, with stands or a hoist, basic hand tools, and care. Always support the exhaust before removing any mount, and use silicone spray or suitable pliers to avoid tearing the new rubber. If brackets are bent, welds cracked, or the system needs alignment, it’s best left to a workshop.