Parts for your 2016 Toyota Wish-Brake shoes

2016 Toyota Wish brake shoes — what they are and when to replace them

Based on Toyota technical references, brake shoes are indeed relevant to the 2016 Toyota Wish. The Toyota Electronic Parts Catalogue (EPC) for the ZGE2# series lists a parking brake shoe set alongside rear disc brakes, and the Toyota Repair Manual for the Wish ZGE2# series describes a drum-in-hat (drum-in-disc) parking brake that uses internal brake shoes. That means the main rear brakes are discs, but the parking brake function relies on brake shoes inside the rear rotor “hat”.

On a 2016 Toyota Wish, the brake shoes are part of the mechanical parking brake assembly. They sit inside the rear brake rotor and press outward on a small internal drum to hold the car when parked. Unlike the hydraulic service brakes (the discs and pads you use to slow down), these shoes are primarily for parking and emergency holding. Because they don’t handle regular stopping, they usually wear slowly — but they can glaze, rust up, or go out of adjustment, which weakens hill-hold performance or causes scraping noises.

During routine servicing, it’s smart to inspect and service the parking brake shoes whenever the rear rotors are off, or at least every 12 months/20,000 km. A technician will check lining thickness, look for contamination (brake fluid or grease), clean dust and light corrosion, and lubricate the correct pivot points and backing plate contact spots. They’ll also adjust the star wheel inside the assembly and then fine-tune the cable so the lever travel is crisp without dragging.

• Signs they need attention: poor holding on inclines, excessive lever travel, grinding/scraping from a rear wheel, or a parking brake warning during inspection.
• Replacement tips: always replace shoes in axle sets, renew the spring/hardware kit, clean the drum surface in the rotor hat, and de-glaze or replace the rotor if badly scored. After fitting, perform a bedding-in procedure with gentle parking brake applications at low speed.
• What not to do: don’t over-tighten the cable to “cheat” a worn shoe, and don’t use general-purpose grease on friction faces — keep lubricants to the specified contact points only.

Look after these little shoes and the Wish’s parking brake will bite properly, pass WOF/rego checks, and stay reliable for years.

Popular questions

Does the 2016 Toyota Wish have rear drum or disc brakes?
The 2016 Wish uses rear disc brakes for normal stopping, but the parking brake is a drum-in-hat design with internal brake shoes. So it has discs for driving and shoes for holding when parked.

How often should 2016 Wish brake shoes be replaced?
They usually last a long time because they’re not used for regular braking. Inspect every 12 months/20,000 km and replace if linings are thin, contaminated, cracked, or if adjustment can’t restore holding power.

Can the parking brake be adjusted instead of replacing the shoes?
Yes. Properly adjusting the shoe star wheel and then the cable often restores lever feel and hold. If the shoes are worn or glazed, though, replacement and a hardware refresh is the better fix.