Parts for your 2016 Toyota C-hr-Brake shoes

2016 Toyota C‑HR brake shoes — are they used on this model?

The 2016 Toyota C‑HR does not use brake shoes. This model is equipped with disc brakes front and rear, and it runs an electronic parking brake that actuates the rear calipers, not a drum‑in‑hat system. In other words, there are brake pads and rotors at each end, but no rear drum assemblies and no brake shoes to service.

Technical sources that confirm this setup include Toyota’s New Car Features (C‑HR, 2016 launch), Toyota Repair Manual/Service Information for the C‑HR (AX10/AX50 series), and ANZ/European specification sheets issued at model introduction. These documents list ventilated front discs, solid rear discs, and an electronic parking brake with integrated rear caliper actuators, eliminating the need for separate parking brake shoes.

• Toyota C‑HR New Car Features (2016): rear solid discs, EPB with motor‑on‑caliper
• Toyota Service/Repair Information: rear brake service uses pads/rotors, no drum shoes
• ANZ/EU launch specifications: ventilated front discs, solid rear discs, electronic parking brake

Why no brake shoes? Brake shoes live inside drum brakes or in a “drum‑in‑hat” parking brake that sits inside a rear rotor. The C‑HR’s EPB screws the rear caliper pistons in and out electrically, so the parking function is handled by the pads gripping the rotor. It’s lighter, simpler to package, and integrates neatly with stability control and auto‑hold features.

For owners and workshops, that means brake maintenance on a 2016 C‑HR focuses on pads, rotors, fluid, and EPB service procedures:

• Use EPB service/maintenance mode before retracting rear caliper pistons (via scan tool or approved sequence).
• Inspect pad thickness, rotor condition, and caliper slide pins every service or 10,000–15,000 km.
• Replace pads/rotors as required, bed‑in pads properly after fitment.
• Flush brake fluid about every two years, climate and usage depending.

No shoe adjustments, replacements, or drum hardware are applicable because the vehicle simply doesn’t use them.

Does the 2016 Toyota C‑HR have rear drum brakes or brake shoes?

No. It has disc brakes at the rear and an electronic parking brake that works the rear calipers. There are brake pads and rotors, but no drum assemblies or brake shoes to service or adjust.

How is the parking brake handled if there are no shoes?

The electronic parking brake uses a small motor on each rear caliper to clamp the pads onto the rotor. This replaces the traditional cable‑and‑shoe arrangement and allows features like auto‑hold and integration with vehicle stability systems.

What should be done when servicing the rear brakes on a C‑HR with EPB?

Always place the EPB into service mode before pushing the pistons back, then check pad thickness, rotor wear, and slide pins. After refitting, exit service mode, perform a pad bed‑in, and confirm EPB operation. No brake shoe work is required because the car doesn’t have them.