Parts for your 2016 Honda Cr-v-Exhaust mount

2016 Honda CR‑V Exhaust Mounts

Yes, the 2016 Honda CR‑V absolutely uses exhaust mounts (also called exhaust hangers or rubber insulators). Honda’s factory service information and OEM parts catalogues for the 2015–2016 CR‑V show multiple rubber hanger insulators supporting the exhaust from the mid‑pipe through to the rear muffler. Those illustrations list “exhaust insulator” components at the centre pipe and muffler brackets, confirming the part is fitted on Aussie and Kiwi models.

On this CR‑V, the exhaust mounts’ job is simple but critical: suspend the exhaust system off the subframe and body, isolate vibration, and keep the pipework and muffler aligned so nothing knocks on the floorpan or bumper. The mounts are heat‑resistant rubber, but over time they harden, crack, elongate or tear from heat cycles, road grime, and a bit of off‑road dust. When they’re tired, drivers may notice a droopy tailpipe, a rattle over bumps, a thud on start‑up or shutdown, or an annoying boom in the cabin.

Typical 2016 CR‑V setups in Australia and New Zealand run about three rubber mounts: one around the mid‑pipe/resonator area and two at the rear muffler. Replacement is straightforward and a smart add‑on during routine servicing.

• Tell‑tale signs it’s time: visible cracks or splits in the rubber, mounts stretched oval, excessive exhaust movement by hand, or the tailpipe sitting off‑centre in the bumper cut‑out.
• Service tip: inspect them at each service or every 20,000 km, many last 5–10 years, but towing, short trips, or coastal exposure can shorten life.

For replacement, support the exhaust with a stand, then spritz a little silicone spray on the pegs. Pop the old insulators off with hanger pliers or a pry bar, slide new quality OEM‑spec insulators on, and check clearances around the subframe, heat shields and bumper. Avoid stressing the flex joint and O2 sensor wiring while you work. If any metal brackets are bent or rusty, sort those at the same time so the new rubbers aren’t doing double duty.

Choosing decent mounts matters. Cheap, soft rubber can sag quickly and bring the rattle right back. A quick road test over a few speed humps after fitting will confirm the exhaust sits sweet and quiet, just like it should.

Popular questions about 2016 Honda CR‑V exhaust mounts

How many exhaust mounts are on a 2016 CR‑V?
Most 2016 CR‑V models in AU/NZ have about three rubber mounts: one at the centre pipe and two at the rear muffler. Variations can exist by trim or market, so a quick look underneath or a VIN check at a Honda parts counter will confirm your exact setup.

How often should exhaust mounts be replaced?
There’s no strict interval. Inspect them during regular servicing or every 20,000 km. Many last 5–10 years, but heat, towing and coastal conditions can accelerate wear. Replace at the first signs of cracking, elongation, or excess movement.

Is it safe to drive with a broken exhaust mount?
It’ll usually move or rattle rather than fail immediately, but driving like that risks bending brackets, melting the bumper, or stressing the flex joint. It’s best to sort it promptly to avoid bigger repair bills.