Your Selected Vehicle
Parts for your 2016 Honda Accord-Engine oil
Castrol EDGE Synthetic 5W-30 Engine Oil 5L - 3421196
Castrol EDGE A3/B4 5W-40 Engine Oil 5L - 3421235
Castrol EDGE C5 0W-20 Engine Oil 5L - 3435256
Explore 4WD & Adventure
Castrol Magnatec A5 5W-30 Engine Oil 10L - 3437808
Penrite Vantage Semi Synthetic 10W-30 Engine Oil 6L - VANSEMI10W30006
Castrol Magnatec DX 5W-30 Engine Oil 5L - 3432803
Castrol Transmax Multi-vehicle Dex/Merc Automatic Transmission Fluid 4L - 3428483
Castrol EDGE Synthetic A3/B4 5W-30 Engine Oil 1L - 3421197
Castrol EDGE LL 5W-30 Engine Oil 20L - 3431129
Penrite Vantage Semi Synthetic 10W-40 Engine Oil 6L - VANSEMI10W40006
Nulon Long Life Green Coolant Concentrate 5L - LL5
Nulon Apex+ Multi-23 Diesel 5W-30 Engine Oil 7L - APX5W30C23-7
Castrol Magnatec Diesel DX 5W-40 Engine Oil 10L - 3422230
Valvoline SynPower 0W-20 Engine Oil 6L - 1333.06
Castrol Magnatec DX 5W-30 Engine Oil 1L - 3432802
Castrol EDGE M 5W-40 Engine Oil 20L - 3426982
2016 Honda Accord engine-oil: what it does and when to change it
Engine-oil is absolutely relevant and used on the 2016 Honda Accord. Technical sources like the 2016 Accord Owner’s Manual, Honda’s Maintenance Minder system documentation, and Honda workshop literature specify SAE 0W‑20 engine oil for the petrol 2.4‑litre i‑VTEC and 3.5‑litre V6 engines. These sources also outline service intervals, oil capacities, and filter replacement, confirming engine-oil is a required service item on this model.
In a 2016 Accord, engine-oil does the heavy lifting every time the key turns. It lubricates moving parts to cut friction and wear, carries heat away from hot spots, keeps internals clean by suspending contaminants, provides a seal around piston rings, and helps protect against corrosion. On Honda’s i‑VTEC engines, clean, correct‑grade oil is also vital for precise valve timing control, so skimping here can quickly lead to rough running or costly repairs.
Honda specifies full‑synthetic SAE 0W‑20 meeting API SN (or later, such as SP) and ILSAC GF‑5/GF‑6. Typical refill quantities are approx. 4.2 litres for the 2.4‑litre and approx. 4.3 litres for the 3.5‑litre V6 when changing the filter. Always verify on the dipstick after filling, as slight variations occur. Genuine Honda 0W‑20 is ideal, but any quality oil that meets the spec will do the job.
For servicing in Australia and New Zealand, follow the Maintenance Minder on the dash, it calculates oil life based on driving conditions. As a practical guide, many owners see changes around 10,000–15,000 km or 12 months, whichever comes first. If the Accord mostly does short trips, towing, hot/cold extremes, or dusty roads, shorten that to about 5,000–7,500 km. Replace the oil filter at every change and fit a new sump plug crush washer. Tighten the drain bolt to around 39 N·m and the filter per manufacturer guidance (usually hand‑tight plus 3/4 turn). Run the engine, check for leaks, then recheck the level. Dispose of used oil responsibly.
- Handy signs it’s time for engine‑oil: the Maintenance Minder indicates service, the oil on the dipstick is very dark and gritty, the engine sounds a bit tappety on cold starts, or fuel economy drifts off.
- Owner tips: keep a 1‑litre top‑up bottle of 0W‑20 in the boot, check the level monthly on level ground a few minutes after shut‑down, and keep an eye out for weeps around the filter and sump plug after a service.
Popular questions about 2016 Honda Accord engine-oil
What oil grade does a 2016 Honda Accord use?
Honda specifies full‑synthetic SAE 0W‑20 meeting API SN or later and ILSAC GF‑5/GF‑6. Genuine Honda 0W‑20 is recommended, but any reputable brand that meets those standards is fine.
How often should the engine-oil be changed on a 2016 Accord in Australia/NZ?
Use the Maintenance Minder as the primary guide. Many see changes around 10,000–15,000 km or 12 months. For frequent short trips, heavy loads, or dusty conditions, aim for about 5,000–7,500 km.
How much oil does the 2016 Accord take?
Approximate refill with filter: 2.4‑litre engine ~4.2 litres, 3.5‑litre V6 ~4.3 litres. Always confirm on the dipstick after filling and topping up.