Parts for your 2016 Ford Mondeo-Centre bearing

2016 Ford Mondeo centre-bearing — is it a thing?

For the 2016 Ford Mondeo sold in Australia and New Zealand, a centre-bearing (also called a prop shaft centre support bearing) isn’t fitted or relevant. Technical documentation for the CD391/MD Mondeo platform shows these cars use a transverse engine with front-wheel drive, so there’s no longitudinal propeller shaft running down the car that would need a centre-bearing.

Technical sources that back this up include the Ford Workshop Manual for the 2015–2018 Mondeo (CD391), which covers front drive halfshafts and an engine-mounted intermediate shaft support, but lists no propeller shaft or centre support bearing for AU/NZ models. Ford’s service information (ETIS/Service Info) and the Ford/Microcat parts catalogue for MD Mondeo VINs likewise show no centre-bearing component. Independent data aggregators (e.g., Autodata) list Mondeo MD as FWD only for local spec, again with no prop shaft assembly.

Why it isn’t used comes down to the drivetrain layout. The Mondeo’s transaxle sends power directly to left and right front driveshafts. To control torque steer and keep shaft lengths balanced, many Mondeo variants use a right-hand intermediate shaft with a bracket and bearing mounted to the engine block or subframe. That support bearing is sometimes casually called a “carrier,” but it’s not a driveshaft centre-bearing — it supports a short intermediate shaft in a FWD setup, not a long rear prop shaft.

One caveat: some overseas Mondeo models (mainly select European AWD trims) do run a rear prop shaft, and those vehicles can use a centre support bearing. Those AWD variants weren’t offered in Australia or New Zealand for the 2016 model year, so local cars won’t have (or need) a centre-bearing.

• If there’s vibration or a droning noise under load in a 2016 Mondeo, workshops typically check front CV joints, wheel bearings, engine/trans mounts and, where fitted, the RH intermediate shaft support bearing — not a centre-bearing.
• Parts searches for MD Mondeo AU/NZ that return a “centre-bearing” usually refer to non-applicable global listings or AWD-only components from other markets.

Popular questions about 2016 Ford Mondeo centre-bearing

Does a 2016 Ford Mondeo have a centre-bearing?
For AU/NZ models, no. They’re front-wheel drive and don’t use a rear prop shaft, so there’s no centre-bearing to service or replace. Any bearing support you’ll find is for the right-hand intermediate shaft in the FWD driveline.

Is the intermediate shaft bearing the same as a centre-bearing?
Different job. The intermediate shaft bearing mounts to the engine/subframe to support a short shaft to the RH front wheel. A centre-bearing supports a long prop shaft in RWD/AWD layouts. The Mondeo’s bearing isn’t a prop shaft centre support.

Are there any Mondeos that do use a centre-bearing?
Certain overseas AWD Mondeo variants may use a prop shaft with a centre support bearing. Those trims weren’t sold new in Australia or New Zealand for 2016, so local MD cars don’t have one.