Parts for your 2016 Daihatsu Bego-Gas struts

2016 Daihatsu Bego gas struts

Short answer: the 2016 Daihatsu Bego doesn’t use gas struts from factory. That’s not a glitch or a cost-cut — it’s the way the J200-series Bego/Terios (also sold as the Toyota Rush) is designed. Technical references including the Daihatsu J200/J210 service manual (Body section), the Toyota Rush owner’s manual (2015–2016), and the Daihatsu electronic parts catalogue show a side-hinged rear door with a mechanical door check/stay and a bonnet supported by a prop rod, with no gas springs listed for either end.

Why no gas struts? The Bego’s back door is a full, side-opening unit with the spare wheel mounted externally. That layout suits a robust mechanical check strap that holds the door at set positions without the progressive force of a gas strut. Gas struts are typically used on lift-up tailgates, on a side-hinged door they can over-assist, fight the hinge geometry, and cop a hard life off-road. Up front, the bonnet’s simple prop rod keeps weight and complexity down, is dead easy to service, and performs reliably in dusty, bumpy conditions — spot on for the Bego’s brief.

What to service instead of “gas struts”? Focus on what the Bego actually has:

• Back door check/stay: Inspect for wear or binding, ensure the detents hold, and lubricate pivot points lightly.
• Hinges and latch: Clean, lube, and adjust so the side-hinged door closes square without slamming.
• Bonnet prop rod and grommets: Make sure the rod is straight, clips securely, and the grommets aren’t perished.

Keen on upgrades? Aftermarket bonnet strut kits exist for some J200-series models, but fitment varies. Check for proper brackets, clearance to the guard and engine cover, and that the bonnet opens to a safe height. For the rear, retrofitting a gas strut to the side-hinged door isn’t generally recommended, it can load the hinges oddly and interfere with the door check. If a softer open/close feel is the goal, a fresh OEM-style door check and proper hinge alignment usually work a treat.

• Does the 2016 Daihatsu Bego have factory gas struts?
  No. Factory documentation for the J200-series Bego/Terios/Toyota Rush shows a side-hinged rear door with a door check and a bonnet prop rod — no gas springs. If you’re shopping for tailgate or bonnet struts for this model, you won’t find genuine listings because they weren’t fitted.
• Can gas struts be retrofitted to the bonnet or rear door?
  Bonnet: Possibly, with a model-specific kit that includes brackets and hardware. Check clearance and opening angle, and have it fitted by someone who knows the platform.
  Rear door: Not advised. The door is side-hinged with a check strap, adding a gas strut can upset the geometry and hinge loads.
• What should be serviced if there are no gas struts?
  Look after the back door check/stay, hinges, and latch, clean and lubricate them and adjust as needed. For the bonnet, ensure the prop rod, clip, and grommets are sound. These small jobs make the Bego’s doors feel smoother and last longer.