Parts for your 2016 Audi Q5-Exhaust mount

2016 Audi Q5 Exhaust Mounts

Exhaust mounts are absolutely used on the 2016 Audi Q5 (Type 8R). Audi’s factory repair information (ElsaWin/ElsaPro – Exhaust system, removing and installing) specifies multiple rubber mounting elements and brackets supporting the exhaust from the downpipe through the centre resonator to the rear mufflers. The official Audi parts catalogue (ETKA) for the 8R Q5 also lists several exhaust suspension components, including rubber hangers and mounting hardware. So, yes—exhaust mounts are relevant and fitted on this model.

On a 2016 Audi Q5, the exhaust mounts (often called hangers) are the tough little rubber cushions and brackets that hold the exhaust system in place under the car. Their job is to suspend the pipework and mufflers, isolate vibration, and keep everything aligned so the exhaust doesn’t knock the body, heat shields, or rear subframe. They also allow a bit of controlled movement, which protects welds and joints from stress as the system heats and cools.

Over time, heat, road grime, and good old Kiwi/Aussie conditions can harden, crack, or stretch the rubber. When that happens, the exhaust can sag or shift, causing rattles, clunks over bumps, or an annoying buzz at idle. Left too long, a droopy system can stress flex joints and clamps, which means bigger bills down the track.

As part of routine servicing, it’s smart to check the Q5’s exhaust mounts every service or roughly every 20,000–30,000 km. Look for perished rubber, splits, elongation of the hanger holes, or shiny rub marks nearby that hint at contact. Replacement is straightforward with the right access: support the exhaust, unhook the tired rubber, and fit a quality OEM-equivalent mount. A dab of silicone spray helps the new rubber slide on. Always check alignment and clearances after fitting and tighten any brackets to factory specs per the Audi workshop manual.

• Common signs it’s time: rattling at start-up or idle, thuds over bumps, tailpipe sitting off-centre, or visible cracks in the rubber.
• Best practice: replace mounts in pairs or as a set in the affected area to keep the system sitting even.
• Pro tip: if one mount has failed from age, the others won’t be far behind—bundle the job to save repeat labour.

Fresh exhaust mounts keep the Q5 quiet, comfy, and compliant—exactly how it left the factory.

How often should exhaust mounts be replaced on a 2016 Audi Q5?

There isn’t a fixed interval, but inspection every service is wise. Many owners find mounts need attention somewhere between 7–10 years or 100,000–150,000 km, depending on climate and driving. Replace on condition—cracks, sagging, or noise are the cues.

What are the tell-tale signs an exhaust mount has failed on a Q5?

Listen for rattles or knocks at idle or over speed bumps, feel for extra vibration in the cabin, and look for a wonky or low-sitting tailpipe. If the exhaust is tapping heat shields or the rear bumper, a mount is likely tired.

Can a DIYer replace Q5 exhaust mounts at home?

Yes, with safe access (ramps or stands), basic hand tools, and penetrating oil or silicone spray. Support the exhaust before unhooking anything. If brackets are rusty or the system needs alignment, a workshop with a hoist can save time and hassle.