Your Selected Vehicle
Parts for your 2015 Honda Accord-Exterior bulbs
Narva 12V Gen III LED BAU15S Resistor-Free Indicator Globes (2) - 18272BL
Narva 12V Gen III LED T10 Wedge Globes with Canbus (2) - 18244BL
Explore 4WD & Adventure
Narva 12/24V Gen III LED T15 High Power Reverse Globes (2) - 18284BL
Narva 12/24V Gen III LED T20 High Power Reverse Globes (2) - 18282BL
Narva 12V Gen III LED BAY15D P21/5W Globes with Canbus (2) - 18266BL
Narva 12/24V Gen III LED BA15S High Power Reverse Globes (2) - 18280BL
Narva T-10mm W5W Premium Wedge Globe W2.1 X 9.5D 12V 5W Single Blister Pack - 17177BL
2015 Honda Accord exterior bulbs — what they do and how to look after them
Based on Honda’s 2015 Accord Owner’s Manual and the factory service/parts catalogues, exterior bulbs are absolutely used on this model. The car relies on replaceable bulbs for headlights, indicators, tail and brake lamps, reverse lights, fogs, number-plate lamps and side markers. Some trims also feature LED daytime running lights, and in certain markets the high‑mount stop lamp may be an LED module, those LED units are typically not user‑serviceable and are replaced as an assembly per Honda service guidance.
Exterior bulbs do the heavy lifting for safety and compliance. They make the Accord visible, signal its intentions, and light the road ahead. On a 2015 Accord, they’re standard service items, and keeping them in top nick helps avoid defect notices, WoF/RWC knockbacks, and annoying warnings like a fast‑flashing indicator when a bulb’s blown. If night vision looks dimmer than usual, or the tick rate speeds up when indicating, it’s time to check.
When replacing bulbs, matching the correct type and wattage listed in the owner’s manual is key to preserving beam pattern and avoiding melted sockets or blown fuses. Halogen headlight bulbs fade with age, so replacing in pairs keeps light output even. Don’t touch the glass with bare fingers—oil shortens bulb life. On some variants, access to headlight or fog light bulbs can be tight and may require inner‑guard or under‑tray clips to come out, that’s normal and covered in Honda’s service procedures.
- Inspect exterior lights at each service and before long trips, confirm high/low beam aim after any front‑end work.
- Clean lenses and check for moisture, fix seal leaks to prevent early bulb failure.
- Use quality bulbs that meet ADR/NZS standards, keep a small spares kit in the boot.
- If upgrading to LED, ensure ADR/NZS compliance and correct beam pattern, some positions (e.g., DRLs/CHMSL) may already be LED modules.
- If an indicator flashes rapidly after a change to LED, a CAN‑bus compatible lamp or resistor/appropriate flasher relay may be required.
For anything that looks like a sealed LED unit, or if the bumper needs to come off for access, a workshop following Honda’s procedures can save time and maintain the Accord’s factory finish.
Which exterior bulbs can a 2015 Accord owner replace at home?
Most trims allow owner replacement of headlight, park light, indicator, fog, tail, brake, reverse and number‑plate bulbs. Some DRLs and the high‑mount stop lamp may be LED modules, those are serviced as assemblies. Always confirm access steps and bulb specs in the 2015 Owner’s Manual.
How often should exterior bulbs be replaced?
Halogen bulbs typically last 2–4 years but dim before they die. Check all lights at each service and replace headlight bulbs in pairs. A quick pre‑WoF/rego walk‑around with a mate pressing the pedals and indicators can prevent test failures.
Are LED upgrades legal on a 2015 Accord in Australia and New Zealand?
They’re only legal if they meet ADR/NZS requirements and maintain correct beam pattern, brightness and colour. Plug‑in LEDs in housings designed for halogen may be non‑compliant. Use approved components, aim headlights properly, and ensure indicators flash at the correct rate.