Your Selected Vehicle
Parts for your 2015 Audi Q5-Interior bulbs
Explore 4WD & Adventure
Narva Marine 12V Saturn Dual Colour 75mm LED Interior Lamp with Touch Switch (White/Red) - 87501WRBL
Narva Marine 12V Saturn Dual Colour 130mm LED Interior Lamp with Touch Switch (White/Red) - 87503WRBL
2015 Audi Q5 Interior Bulbs: What They Do and How to Look After Them
Interior bulbs are absolutely fitted to the 2015 Audi Q5 (type 8R). This is confirmed by the Audi Q5 (8R) Owner’s Manual for 2015 in the Lights and vision—Interior lighting section, the Audi Workshop Manual (ElsaWin) under Body—Electrical system—Interior lights, and the Audi ETKA 8R parts catalogue (group 94). Most 2015 Q5s left the factory with incandescent cabin bulbs, while vehicles optioned with the LED Interior Lighting Package use dedicated LED modules in many locations.
These lights make the cabin usable after dark—map and dome lamps for reading, vanity mirror lights, footwell and door puddle lamps for safe footing, glovebox lights to find odds and ends, and a boot lamp so the gear isn’t lost in the gloom. They’re tied into the Q5’s convenience electronics for fade-in/out and delayed switch-off, so they feel premium while staying practical.
For routine servicing, it’s smart to check all interior lamps operate, replace any dull or blown bulbs, and clean the lenses. If swapping to LEDs, choose CAN-bus compatible, error-free lamps so the car doesn’t flag bulb errors or cause flicker. Stick to the correct wattage and voltage, avoid mixing odd colour temperatures, and don’t touch halogen glass with bare fingers—oils can shorten life.
- Common locations and typical fitments (trim-dependent—verify against VIN/parts data): map/dome (C5W 36 mm festoon or W5W/T10), footwell (W5W/T10 or LED module), vanity (C5W 29–36 mm), glovebox (W5W/T10), boot (C5W 36 mm), door puddle (W5W/T10 or LED module).
- Switch off ignition and lights, let hot bulbs cool.
- Use a plastic trim tool to ease the lens or lamp unit out—no screwdrivers on soft trims.
- Note polarity on LEDs, for festoons/T10s, match size and wattage.
- Test before refitting the lens, check fade/dimming works normally.
If a lamp stays on, check the switch position on the overhead console and the MMI lighting settings. Persistent faults can point to a door latch microswitch or a low battery state of charge. For Q5s with the LED package, some lights are sealed modules—replacement is by complete unit rather than a bulb swap, as per Audi’s workshop guidance.
Technical references: Audi Q5 (8R) Owner’s Manual 2015—Lights and vision, Audi Workshop Manual (ElsaWin)—Body Electrical, Interior lighting, Audi ETKA 8R—Electrical equipment (group 94).
Popular questions about 2015 Audi Q5 interior bulbs
What bulb types fit the Q5’s interior?
Most 2015 Q5s use a mix of W5W/T10 wedge bulbs and C5W festoon bulbs (commonly 36 mm) across dome, map, boot and vanity positions. Cars with the LED Interior Lighting Package use dedicated LED modules in several spots. Always confirm by checking the owner’s manual or the vehicle’s VIN in a parts catalogue.
Can the interior bulbs be upgraded to LED without errors?
Yes—use CAN-bus compatible, error-free LEDs of the correct size. Observe polarity, and test dimming/fade. If there’s flicker or bulb warnings, try a quality brand with built-in resistors or restore incandescent in that position.
Why do my interior lights stay on or flicker?
Check the overhead switch settings and MMI lighting options first. If they still won’t time out, a door latch microswitch or low battery voltage could be the culprit. Flicker after an LED upgrade usually means the LEDs aren’t CAN-bus compatible.
