Parts for your 2014 Toyota Hilux-Centre bearing

2014 Toyota Hilux centre-bearing: what it is, who has it, and how to look after it

Referencing technical sources, the centre-bearing is indeed used on most 2014 Toyota Hilux models. The Toyota Hilux N70 series Repair Manual (2005–2015) under the Propeller Shaft section, Toyota’s Electronic Parts Catalogue for KUN/GGN variants, and Australian driveline catalogues used by workshops all document a two‑piece tailshaft with a centre support bearing on dual cab, extra cab and many long‑wheelbase 4x2 and 4x4 models. Short‑wheelbase 4x2 single cabs may run a one‑piece tailshaft and therefore don’t use a centre-bearing. For the majority of 2014 Hilux utes on Aussie and Kiwi roads, the centre-bearing is very much a relevant, serviceable part.

The centre-bearing (also called a centre support bearing) sits mid‑way along the Hilux’s two‑piece tailshaft. Its job is to support the prop shaft, keep driveline angles in check and tame vibration under load. By cradling the shaft in a rubber-mounted bearing, it reduces noise and harshness through the cabin and helps the universal joints live a longer, happier life. When it’s in good nick, take‑offs feel smooth and there’s none of that low‑speed shudder or thump.

As part of routine servicing, a Hilux that runs a centre-bearing benefits from a quick visual and hands‑on check. The bearing itself is sealed (no greasing), but the rubber carrier can perish or split, and the inner race can wear. Common tell‑tales include:

• Shudder or rumble on take‑off, often between 20–60 km/h
• Driveline “clunk” when engaging drive or on overrun
• Visible sagging, cracking or separation of the rubber mount
• Play or roughness when the tailshaft is rotated by hand

When replacement is due, a workshop will typically mark the flanges and splines for balance, support the tailshaft, remove the centre bracket, press off the old bearing and carrier, then press on the new unit in the correct orientation. It’s smart practice to inspect the universal joints and slip yoke at the same time, and renew bolts or use appropriate thread locker on reassembly. The centre bracket should be tightened with the ute at normal ride height so the rubber mount isn’t pre‑loaded at an odd angle. If any vibration remains, a driveline balance check is worth doing. Quality matters here