Parts for your 2014 Subaru Exiga-Exterior bulbs

2014 Subaru Exiga exterior bulbs — what they do and how to look after them

Based on technical sources including the 2014 Subaru Exiga/Liberty Exiga Owner’s Manual (Lighting section), the Subaru factory Service Manual (Chassis: Lighting System), and Subaru FAST genuine parts listings, the 2014 Subaru Exiga is absolutely fitted with exterior bulbs. These cover low and high beam headlights, front and rear indicators, fog lamps (on equipped trims), reverse lights, stop/tail lamps and number-plate illumination.

Exterior bulbs are there for two big reasons: seeing and being seen. They light the road ahead, mark the car’s size and position, and signal intent to other road users. Keeping them working isn’t just polite—it's required under the Australian Design Rules and NZTA vehicle standards. Poor bulbs or mismatched wattage can lead to dodgy beam patterns, glare, defect notices, or worse, a prang.

When it’s time to replace a bulb, the smart play is to check the exact spec in the owner’s manual or by VIN against a trusted parts catalogue. The Exiga was offered in variants that may use different bulb types (some trims feature HID low-beams), so guessing isn’t ideal. Stick to the correct base and wattage, and avoid touching the glass on halogen bulbs—skin oils can shorten their life. Replacing in pairs (left and right) helps keep colour and brightness consistent. After fitting, confirm the headlight aim and ensure the dust caps and seals are back on snug to keep moisture out.

For HID/Xenon-equipped models, there’s high voltage at play. The service manual flags special handling for discharge lamps and ballasts, so if the car has factory HID, it’s best to have a qualified auto sparky or workshop handle it. The same goes if a bulb change requires significant trim removal. Steer clear of non-compliant LED retrofits in housings designed for halogen, they can cause glare and may not meet ADR/NZTA requirements.

• Do a quick lamp check monthly—park near a wall and test every function.
• Replace blown fuses with the correct rating and investigate repeat failures.
• Keep lenses clean, dirt scatters light and reduces effectiveness.
• Watch for condensation, reseal caps and check gaskets if you see fogging.
• Carry a small spare-bulb kit on road trips for an easy roadside fix.

What bulb types does a 2014 Subaru Exiga use?

It varies by trim and market. Many cars run halogen low/high beams, while some Exiga variants use HID low-beams. Indicators, stop/tail, reverse and number-plate lamps are typically replaceable wedge or bayonet bulbs. The safest route is to confirm by VIN in a Subaru parts catalogue or check the owner’s manual to match base type and wattage before buying.

How often should exterior bulbs be replaced?

There’s no fixed interval—replace on condition. Do a quick check every month or two and swap any tired, dim or flickering bulbs before they fail fully. Replacing in pairs keeps light output even. If night driving is frequent, consider long-life halogen options that meet ADR/NZTA specs.

Can the bulbs be changed at home?

Yes, many can. Headlight bulbs are typically accessed behind the headlamp via a dust cap, tailgate and rear lamps may need a trim panel unclipped. Always turn the lights off, let hot bulbs cool, and avoid touching halogen glass. If the car has HID low-beams or access is tight, a workshop job is the safer bet.