Your Selected Vehicle
Parts for your 2014 Nissan Dualis-Headlights
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
Explore 4WD & Adventure
LED Autolamps Multi Volt Rear Indicator Lamp With 8 Square LEDs Blister Pack With Black Base - 135AM
LED Autolamps 12V Blue Courtesy Lamp Super Small Design Twin Blister Pack - 16B12-2
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIMCSB
LED Autolamps Multi Fit Steel Bracket To Suit 280/282/275/80/283/284 Triple Combination Lamps - MFBKT
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps 12V Stop/Tail/Indicator Assembly 3 Lamps With 108 LEDs Black Bracket - 80BARR
LED Autolamps Rear Taillight Harness To Suit MY22 Ranger / MY20 Ram Plug To Bare Wires - PATCH-RAM.UNI
LED Autolamps 174 Series Stop/Tail Lamp 12/24V, Surface Mount, 40cm Cable - 174RMB
LED Autolamps 12/24V 16 LED Stop/Tail Indicator Lamp Black Bracket Blister Pack - 201BSTIM
LED Autolamps 12V Interior Strip lamp Touch Sensor Switch With MCU Circuitry - 40260SMCU
LED Autolamps 12/24V Round Indicator Lamp With Clear Lens 130mm Diameter Recessed Mount - 102ACM
LED Autolamps Multi Volt Round Indicator Lamp With Amber Lens Recessed Mount - 102AM
2014 Nissan Dualis Headlights
Headlights are absolutely fitted to the 2014 Nissan Dualis. This is confirmed by Nissan’s factory service information for the J10 Qashqai/Dualis platform and owner’s manual guidance on bulb replacement, as well as Australian and New Zealand road rules (such as ADR 13/00-style lighting requirements) that mandate compliant headlamps on passenger vehicles. So headlights are relevant to this model and a key safety feature.
On the 2014 Dualis, the headlights provide clear forward illumination on low beam for everyday driving and a longer throw on high beam for country roads. They also make the vehicle visible to others, helping with road safety at dawn, dusk, and in poor weather. Most trims run halogen lamps, while higher-spec variants may have factory Xenon/HID units with auto-levelling and washers.
As part of regular servicing, it’s smart to inspect and maintain the headlight system. Common-sense care goes a long way:
- Check operation of low and high beam every service interval (around 10,000 km or 6 months).
- Replace bulbs in pairs to keep brightness and colour consistent. Avoid touching the glass, hold by the base.
- Keep lenses clean with pH-neutral car shampoo. Skip harsh solvents that can haze the plastic.
- If one side looks dim, inspect the connector and earth points for corrosion.
- Verify headlight aim after suspension work, front impacts, or when carrying heavy loads. Factory HID systems auto-level, halogen setups use manual adjusters on the housing.
- Fogging that clears after a drive is usually normal, persistent pooling of water means the housing seal needs attention.
DIY bulb changes on halogen units are typically straightforward via the service caps behind the headlamp under the bonnet: disconnect the plug, release the holder, swap the bulb, and refit. For factory HID/Xenon systems, high voltage and levelling hardware make professional handling the safer bet.
Thinking upgrades? Quality halogen replacements can lift performance while staying compliant. LED or HID conversions in halogen reflectors are generally not road-legal in AU/NZ unless the whole assembly is approved and certified, so double-check local rules before changing tech.
Popular questions about 2014 Nissan Dualis headlights
What bulb types fit the 2014 Nissan Dualis?
Bulb types vary by trim and market, and the Dualis had both halogen and some factory Xenon/HID options. Many halogen models use separate bulbs for low and high beam. The sure-fire way is to check the owner’s manual or a VIN-based parts catalogue, or read the markings on the rear caps of the headlamp.
How do you adjust the headlight aim?
Park on level ground about 5 metres from a wall, measure the cut-off against the manufacturer’s spec, and turn the vertical (and if fitted, horizontal) adjusters on the back of each housing in small increments. If the vehicle has factory HID with auto-levelling, or if you’re unsure of the reference heights, a workshop can set aim precisely with a beam setter.
Are LED or HID conversions legal on this model?
In Australia and New Zealand, fitting LED or HID bulbs into halogen headlamp units is generally not road-legal unless the entire assembly is certified and compliant. Factory Xenon/HID systems are fine. If you want more light while staying legal, choose quality halogen upgrades or an ADR-compliant replacement assembly.