Parts for your 2014 Mitsubishi Asx-Exterior bulbs

2014 Mitsubishi ASX exterior bulbs — what they do and how to look after them

Exterior bulbs are absolutely fitted to the 2014 Mitsubishi ASX and they’re a core safety item. Technical sources such as the 2014 ASX Owner’s Manual and the Mitsubishi Genuine Parts Catalogue outline a mix of halogen and conventional incandescent bulbs across the headlights, indicators, brake and tail lamps, reverse, fog lamps and number-plate lights, with some trims featuring LED daytime running lights. In short, this ASX relies on exterior bulbs for visibility and signalling, keeping the vehicle compliant and safe on Aussie and Kiwi roads.

Their job is simple but critical: help the driver see at night and in poor weather, and clearly signal intent to others. Headlights light the way, indicators and brake lights communicate moves, and reverse and number-plate lamps round out legal requirements. Because bulbs are wear items, they should be checked routinely and replaced promptly when they age or fail.

During servicing, a quick walk-around is smart practice—switch on low/high beam, indicators, hazards, brakes, reverse and fogs to confirm everything’s working. Dim, pinkish or blackened glass, or a rapid indicator flash, usually points to a bulb on the way out. If one headlight or brake light fails, it’s wise to replace the pair on that circuit so brightness stays even.

When replacing, always match the correct fitment and wattage specified for the ASX. Avoid touching halogen bulb glass with bare fingers—skin oils can shorten bulb life—so use gloves or a clean tissue. Access varies by lamp: some headlight bulbs are reached from behind the headlamp inside the engine bay, rear bulbs are typically accessed via panels inside the tailgate area. If moisture is present in a lamp, inspect seals and caps before fitting a new bulb. For trims with LED DRLs, the LED element may be part of a non-serviceable module, if it fails, the assembly or module is replaced rather than a simple globe.

• Test all lights after replacement and ensure connectors are fully seated.
• Stick with ADR/NZS-compliant, quality bulbs, avoid higher-wattage “upgrades” that can overheat housings.
• If a new bulb still doesn’t light, check fuses and earth points before chasing wiring faults.

What bulb types does a 2014 Mitsubishi ASX use?

Most 2014 ASX models use halogen bulbs for headlights and conventional incandescent bulbs for indicators, brake/tail, reverse, fog and number-plate lights. Some trims include LED daytime running lights. Exact fitments can vary by market and trim, so confirming via the owner’s manual or a Mitsubishi parts lookup using the VIN is the safest bet.

Why is my ASX indicator flashing fast?

A rapid flash (hyperflash) usually means an indicator bulb is blown or the wrong wattage bulb has been installed. Check front and rear indicator bulbs and replace like-for-like. If aftermarket LED indicator bulbs have been fitted, an LED-compatible flasher or load resistors may be required to restore the normal flash rate.

How often should the exterior bulbs be checked or replaced?

Give them a once-over at every service or at least every six months, and before long night drives. Replace at the first sign of dimming or failure. Keeping a small spare bulb kit and fuses in the ASX is handy for road trips around Australia or New Zealand.