Parts for your 2014 Mitsubishi Asx-Brake hose

2014 Mitsubishi ASX Brake Hose — What It Does and When to Replace It

Based on technical sources including the Mitsubishi ASX (GA-series) service manual brake section (hydraulic piping and flexible hose procedures) and the Mitsubishi ASA electronic parts catalogue, the 2014 Mitsubishi ASX is fitted with flexible brake hoses at each wheel. These hoses connect the rigid brake lines on the body to the moving components on the suspension and calipers. Aftermarket catalogues from major suppliers used in Australia and New Zealand also list front and rear brake hoses specifically for the 2014 ASX, confirming the part’s relevance.

On the 2014 ASX, the brake hose plays a critical role in the hydraulic braking system. It’s the flexible link that allows brake fluid pressure to reach the calipers while the wheels steer and the suspension moves. Because it flexes constantly and lives close to heat, water, UV, and road grime, it’s a wear item that deserves a regular look during servicing.

For day-to-day motoring, the hose’s job is simple: transmit pressure with zero drama. When a hose starts to degrade—cracking, swelling, or seeping—it can make the pedal feel spongy, lengthen stopping distances, or cause the vehicle to pull under brakes. That’s why most workshops in Aus and NZ will inspect the hoses at every service, and recommend replacement if there’s any sign of damage or ageing.

Good practice for an ASX service plan is:

• Inspect brake hoses every 10,000–20,000 km or 6–12 months, alongside pads, rotors, and fluid.
• Replace immediately if there’s cracking, bulges, chafing, corrosion at fittings, fluid weep, or if the hose feels unusually soft.
• Consider preventive replacement around the 6–10 year mark, especially on vehicles seeing coastal use, towing, gravel roads, or lots of heat cycles.

When replacing, it’s smart to do them in axle pairs (both fronts or both rears) to keep brake response even. A proper job uses flare-nut spanners to avoid rounding fittings, new sealing washers where specified, and correct torque. After installation, the system must be bled thoroughly and the brake fluid brought up to the spec shown on the reservoir cap (commonly DOT 3 or DOT 4). Avoid twisting the hose, with the wheels at full lock both ways, check that there’s no tension or rubbing through the full suspension travel.

If the ASX ever shows a soft pedal, a wet patch at a hose, or a pull under braking, park it up and get it checked—this is a safety-critical part, and fresh hoses are cheap insurance.

Popular questions about 2014 Mitsubishi ASX brake hoses

How often should brake hoses be replaced on a 2014 ASX?
There’s no single kilometre figure for every car, but in Australian and New Zealand conditions many workshops suggest inspection at every service and preventive replacement around 6–10 years. High-heat, coastal, or off‑seal use may bring that forward. Always replace immediately if there’s any visible damage or performance symptoms.

What are the signs a brake hose is failing?
Look for surface cracking, bulges, chafe marks, fluid seepage, or rusty fittings. From behind the wheel, a spongy pedal, increased stopping distance, pulling to one side, or a brake that drags after releasing the pedal can point to hose issues. Any of these should be checked promptly.

Can braided stainless hoses be fitted legally in Aus/NZ?
Yes, provided the hoses are ADR/DOT compliant and installed correctly. In Australia they should meet applicable ADR requirements, in New Zealand, OE‑equivalent or approved braided hoses are fine, while custom or modified systems may require LVV certification. When in doubt, use a reputable supplier and a licensed workshop.