Parts for your 2014 Honda Stream-Brake hose

2014 Honda Stream brake hose — purpose, care and when to replace

Based on the Honda Stream RN6–RN9 workshop manual and Honda’s Electronic Parts Catalogue for the final 2014 model year, the vehicle uses flexible hydraulic brake hoses at each corner. These hoses link the rigid chassis lines to the moving brake calipers (front) and to the rear brake assemblies (disc or drum, depending on variant). So yes, a brake hose is absolutely relevant and fitted to the 2014 Honda Stream.

The brake hose’s job is simple but critical: carry pressurised brake fluid from the hard line to the wheel-end without leaking, swelling, or collapsing. Because the wheels and suspension move, a flexible hose is the only practical way to maintain a sealed connection. When a hose ages, internal layers can crack or delaminate, fittings can corrode, and the hose can swell under pressure — all of which can cause a soft pedal, brake pull, dragging brakes, or fluid leaks.

Good servicing practice for a 2014 Stream is to inspect the brake hoses at every service or at least every 10,000–15,000 km. Look and feel for:

• Cracks, chafe marks, bulges, or damp spots
• Rust at crimped fittings or weeping around banjo bolts
• Hose twist or contact with tyres, struts, or steering components

If any defect is found, replacement is the go. It’s smart to replace hoses in axle pairs (both fronts or both rears) to keep braking response even left-to-right. Use quality parts that meet or exceed OEM spec and new copper washers on banjo fittings. After any hose work, a proper brake bleed is essential to remove air — follow the bleed sequence in the Honda manual. Brake fluid should meet Honda’s specification (typically DOT 3, DOT 4 is often acceptable — check the reservoir cap and manual) and be replaced every two years regardless of kilometres.

DIY’ers should support the caliper, avoid twisting the new hose, and torque fittings to the Honda spec. Any sign of persistent sponginess, uneven pad wear, or the car pulling under brakes after hose replacement is a cue to recheck for air, hose routing, and caliper slide freedom. For WOF or rego inspections across NZ and Aus, tidy, dry, undamaged hoses help ensure a smooth pass and, more importantly, safe stops.

FAQs

How long do brake hoses last on a 2014 Honda Stream?

There’s no hard expiry, but many last 8–12 years in typical Aussie and Kiwi conditions. Heat, UV, road grime, and moisture speed up ageing. If the Stream is still on original hoses, proactive replacement around that age can restore pedal feel and reliability.

Should both front (or both rear) hoses be replaced together?

Yes, replacing in axle pairs is recommended. It keeps the braking response even side-to-side and minimises the chance of one old hose failing soon after the other has been renewed.

What brake fluid should be used after hose replacement?

Use brake fluid that meets Honda’s spec printed on the reservoir cap and noted in the workshop manual — typically DOT 3, with DOT 4 acceptable in many cases. Always use fresh, unopened fluid and bleed until clean, bubble-free fluid runs through each bleeder.