Your Selected Vehicle
Parts for your 2014 Daihatsu Bego-Interior bulbs
Explore 4WD & Adventure
Narva Marine 12V Saturn Dual Colour 75mm LED Interior Lamp with Touch Switch (White/Red) - 87501WRBL
Narva Marine 12V Saturn Dual Colour 130mm LED Interior Lamp with Touch Switch (White/Red) - 87503WRBL
2014 Daihatsu Be go Interior Bulbs
Interior bulbs are absolutely fitted to the 2014 Daihatsu Be go. Technical references including the Daihatsu Be go/Terios J200-series owner’s manual and Toyota Rush (the sister model) parts catalogues specify replaceable 12 V interior courtesy, map, and luggage-compartment lamps using wedge and festoon style bulbs. That means the Be go relies on conventional serviceable bulbs for cabin illumination rather than sealed, non-serviceable modules.
In this model, interior bulbs handle everyday jobs: lighting the cabin when doors open, brightening the map area for quick reading, and making the boot usable after dark. They’re small parts, but they make the Bego feel easy to live with. Over time, bulbs dim, flicker, or fail, so it’s smart to treat them as part of routine servicing.
For most 2014 Be go trims, you’ll typically find W5W (T10) wedge bulbs for map or front courtesy lights and a festoon-type bulb (often 31–36 mm) in the dome and/or luggage area. Exact fitment can vary by trim and market, so it’s best to confirm against the vehicle’s manual, the label inside the lens, or the part number on the removed bulb.
When replacing, match voltage (12 V) and similar wattage to avoid overheating the lens. Upgrading to LED is popular and fine for the Be go—choose quality warm white (around 3000–4000 K) for a factory-like colour, make sure the LED physically fits the housing, and note that wedge LEDs can be polarity sensitive—flip them 180 degrees if they don’t light. If an LED glows faintly when off, a CAN-bus style or a resistor-equipped version can help.
- Switch everything off and let the lens cool.
- Gently pry the lens with a plastic trim tool.
- Swap the bulb like-for-like, avoiding fingerprints on the glass.
- Test before refitting the lens.
If all interior lamps stop at once, check the DOME/ROOM fuse in the cabin fuse box and ensure lamp switches aren’t set to OFF. A sticky door switch can also stop the courtesy function. During servicing, a quick check for heat-discoloured lenses, loose contacts, and water ingress pays off. Keeping a small set of spare bulbs in the glovebox makes roadside fixes easy—very handy on a wet Kiwi evening or an Aussie outback stop.
Popular questions about 2014 Daihatsu Be go interior bulbs
What bulb sizes fit the Be go’s interior lights?
Most 2014 Be go interiors use W5W (T10) wedge bulbs for map/front courtesy lights and a festoon (commonly 31–36 mm) for the dome or boot. Always verify by checking the existing bulb or the owner’s manual, as trims and markets can differ slightly.
Can LED replacements be used inside the Be go?
Yes. Choose 12 V LEDs in the correct wedge or festoon format. Opt for warm white (around 3000–4000 K) to avoid harsh, bluish light. If a new LED doesn’t turn on, rotate it 180 degrees for correct polarity. Some LEDs may glow faintly when off, a CAN-bus or resistor type usually resolves that.
Why did all my interior lights stop working at once?
The most common cause is a blown DOME/ROOM fuse. Check the cabin fuse panel first. Also confirm the lamp switch positions (not set to OFF) and the door-ajar switches. If the fuse repeatedly blows, there may be a short in the circuit that needs attention.
