Parts for your 2013 Toyota Fortuner-Exhaust mount

2013 Toyota Fortuner exhaust mount — what it is, why it matters, and when to replace

Yes, the 2013 Toyota Fortuner uses exhaust mounts. Technical references including Toyota’s workshop manual for the AN60-series Fortuner/Hilux platform (Exhaust Pipe – Removal/Installation) and Toyota’s Electronic Parts Catalogue for 2013 models list multiple “Insulator, Exhaust Pipe” (rubber hangers) and “Bracket, Exhaust Pipe” items along the system. These parts are shown at the front pipe, centre/muffler area, and rear tailpipe, and are specified as serviceable components. That makes exhaust mounts fully relevant to this vehicle.

The exhaust mounts on a 2013 Fortuner support the weight of the exhaust while isolating vibration and allowing controlled movement as the engine rocks and the pipework heats and cools. By keeping the system located but flexible, they help prevent knocks on the body, protect welds and flanges from stress, and reduce cabin boom and rattles — all part of Toyota’s NVH targets for this platform.

For servicing, it’s smart to inspect the mounts at every routine service, especially on vehicles that tow, tour long distances, or see corrugations and off‑road work. After a decade-plus, the original rubber can harden, crack, or elongate, and brackets can rust. On a 2013 vehicle, proactive replacement of tired insulators often restores refinement and prevents costly exhaust damage.

• Common signs they’re due: exhaust sagging or sitting off-centre, thuds over bumps, metallic rattles at idle or start-up, excessive vibration, or the tailpipe tapping the towbar or bumper.

Replacement is straightforward but benefits from the right approach:

1. Support the exhaust so weight isn’t hanging on remaining mounts.
2. Lubricate the rubber insulators with silicone spray and lever them off the pegs, avoid tearing them dry.
3. Inspect and replace any rusty hanger brackets, fit new OE-spec insulators rather than reusing tired rubber.
4. Re-align clearances around the rear axle, spare, heat shields and towbar, then tighten bracket fasteners to the Toyota workshop spec.

Quality OE rubber insulators maintain the Fortuner’s intended ride quality, heavy-duty options can be useful for hard touring but may add a touch more vibration. As part of the same visit, check nearby heat shields, flex joints, and flange gaskets for condition and leaks.

Popular questions

How many exhaust mounts does a 2013 Fortuner have?
Typically three to five, depending on engine and market spec, positioned at the front pipe, mid/muffler, and rear tailpipe. The exact count varies with towbar, spare-wheel placement, and muffler style. A quick look underneath or a glance at the Toyota EPC for the specific VIN will confirm the layout.

How often should the exhaust mounts be replaced?
There’s no fixed interval. Inspect at every service, replace when rubber is cracked, hardened, or elongated, or if the system sags or knocks. On vehicles of this age, pre-emptive replacement can be worthwhile, especially for those that tow or spend time on rough roads.

Are polyurethane mounts a good upgrade for a Fortuner?
They can add durability and control for heavy off-road or towing, but may transmit a bit more vibration into the cabin. For daily use and best NVH, most owners stick with OE-style rubber insulators that match Toyota’s original tuning.