Parts for your 2013 Subaru Exiga-Headlights

2013 Subaru Exiga headlights

Headlights are absolutely relevant and factory‑fitted on the 2013 Subaru Exiga. Technical sources such as the Subaru Exiga Owner’s Manual (Lighting section), Australia’s ADR 13/00 (Installation of Lighting and Light‑Signalling Devices) and New Zealand’s Land Transport Rule: Vehicle Lighting 2004 confirm that compliant headlamps are required and described for this model.

On the Exiga, the headlights do the heavy lifting after dark and in poor weather—helping the driver see the road, hazards and signage, and making the vehicle visible to others. Low beam handles everyday night driving without dazzling oncoming traffic, while high beam throws longer light down country roads. Most 2013 Exiga variants run halogen bulbs, some trims may include projector‑style or HID low beams. Either way, they’re a key safety system and worth a regular look‑over.

As part of routine servicing, it’s smart to test both beams, indicators and parkers, and replace any tired bulbs in pairs so brightness stays even side‑to‑side. Wear clean gloves and avoid touching the glass—skin oils can shorten a halogen bulb’s life. If your Exiga uses HID/Xenon, be aware of high voltage at the ballast, disconnect the battery and follow the manual, or leave it to a qualified tech. Use bulbs that meet ADR/NZ requirements to stay road‑legal, and check the owner’s manual or bulb label under the bonnet for the exact types fitted to your vehicle and market.

Lens care matters, too. Keep the covers clean, and if they’re yellowed or cloudy, a proper headlight restoration can bring back clarity and beam pattern. If the beam looks crooked or you’re getting flashed by other drivers, have the aim checked and adjusted to ADR/NZ specs on a level surface. Flickering, moisture inside the housing, or discoloured connectors can point to wiring, seal, fuse or relay issues—catching these early saves bigger hassles later.

• Signs it’s time to service: dim or uneven light, flicker on bumps, yellowed lenses, moisture in the housing, or poor night visibility.
• Good habits: replace in pairs, keep lenses clean, verify aim, and use compliant, quality bulbs.

What headlight bulbs fit a 2013 Subaru Exiga?

Bulb types can vary by trim and market. Many Exiga models use halogen low and high beams, while some trims may have HID/Xenon low beams. Check the owner’s manual, the markings on the bulb access covers, or ask a parts specialist with your VIN to confirm the exact fitment.

Are LED bulb upgrades legal for the Exiga in Australia or New Zealand?

LED retrofit bulbs in housings designed for halogen are generally not road‑legal unless specifically approved and compliant with ADR/NZ rules. For WOF/roadworthy compliance and proper beam pattern, stick with approved equipment or complete headlamp assemblies designed for LED.

How do you adjust the Exiga’s headlight aim?

There’s an adjuster on the back of each headlamp. Park the car level with correct tyre pressures and normal load, then adjust so the cutoff meets specification. For the best result and compliance with ADR/NZ targets, have a workshop aim them using a beam setter.