Parts for your 2013 Ford Territory-Exhaust mount

2013 Ford Territory exhaust mount — what it does and when to replace it

Yes, an exhaust-mount (also called an exhaust hanger or insulator) is fitted to the 2013 Ford Territory SZ. This is confirmed by the Ford SZ Territory Workshop Manual (2011–2016) under Exhaust System — Description and Operation, and the Ford EPC/Microcat parts catalogue, which list rubber exhaust insulators supporting the front pipe, centre section and rear muffler. Aftermarket fitment guides for the SZ Territory also specify replacement hangers, so the part is absolutely relevant to this model.

The exhaust-mount’s job is simple but crucial: it suspends the exhaust under the car, isolates vibration so the cabin stays quiet, and keeps the pipework centred to avoid knocking on the body, subframe or towbar. Each rubber insulator shares the weight of the system and allows a bit of movement for heat expansion and engine rock. On the Territory, you’ll typically find mounts near the front pipe/flex, the mid resonator (where fitted), and at the rear muffler/tailpipe.

As part of regular servicing, it’s smart to eyeball the mounts every 10,000–15,000 kilometres or at each oil change. Rubber ages with heat and road grime, and towing or corrugated roads can speed that up. If a mount lets go, the exhaust can sag, stress the flex joint or even strike underbody components. Expect service life anywhere from 60,000 to 120,000 kilometres depending on use and climate.

• Thuds or rattles over bumps or at idle
• Tailpipe sitting off-centre in the bumper cut-out
• Cracked, perished or stretched rubber
• Exhaust visibly sagging or excessive movement
• Burnt rubber smell (mount too close to hot section)

Replacement is straightforward: let the exhaust cool, support it with a stand or jack, spray the old insulator with silicone lube, then lever it off with an exhaust-hanger tool or sturdy pliers. Swap in a quality OEM or equivalent heat-rated rubber insulator, refit in the same orientation, and confirm the pipe clears heat shields and bodywork by at least a finger’s width. If any metal hanger pegs or brackets are bent or rusty, sort those while you’re there, and torque bracket fasteners to workshop-manual spec. After the first couple of drives, recheck alignment and clearances — especially if the vehicle tows or carries a load.

Popular questions

How many exhaust mounts does a 2013 Ford Territory have?
Most SZ Territory variants run three to five mounts, depending on engine and exhaust layout. Expect one near the front pipe, one around the centre/resonator area, and one or two at the rear muffler. Turbo-diesel and towing packages may add bracket variations.

Is it OK to use a universal rubber hanger on a Territory?
Yes, provided the hole spacing, thickness and stiffness closely match the original. Too soft and the exhaust sags, too firm (e.g., some polyurethane types) and you’ll transmit vibration into the cabin. When in doubt, go genuine or a reputable OEM-equivalent.

Can you drive with a broken exhaust mount?
It might get you home, but it’s not ideal. A hanging system can strain the flex joint and catalytic converter, chafe oxygen-sensor wiring, and bang against the floor. Best to support it temporarily and replace the faulty mount promptly.