Parts for your 2013 Ford Falcon-Wiper refills

2013 Ford Falcon wiper refills — fitment, purpose, and easy servicing advice

Technical sources including the Ford Falcon FG MkII Owner’s Manual (wiper maintenance section), Ford Australia scheduled maintenance guidance, and major fitment catalogues from Trico and Bosch for the AU/NZ market confirm that the 2013 Ford Falcon (FG MkII) uses conventional hook-arm wiper blades that accept rubber wiper refills. In other words, refills are relevant and commonly used on this model. Many Falcon owners stick with the factory-style framed blades and simply slide in 8 mm metal-backed refills, while others may choose complete blade assemblies if the frames are worn.

Wiper refills are the replaceable rubber inserts that do the hard work across the windscreen. On a 2013 Falcon, their job is simple but crucial: maintain a clear view in wet weather, cut glare at night by sweeping away film, and protect the glass by gliding cleanly without chatter. Because Aussie and Kiwi UV, heat, and road grime are tough on rubber, the refills naturally harden and lose their edge over time.

As part of routine servicing, Falcon owners are well served by inspecting the refills every service or around 10,000–15,000 kilometres, and planning replacement every 6–12 months depending on climate and use. Tell-tale signs it’s time include streaking, squeaks, judder, frayed edges, or a hazy film that won’t shift. Cleaning the blade with a damp cloth and a bit of washer fluid between services helps extend life.

When fitting, the key points are straightforward: match the refill width (most FG-series Falcons take 8 mm metal-backed refills in the original frames), confirm the correct lengths per a trusted fitment guide, and slide the new inserts in the same direction they came out so the locking tab engages. If the blade frames are loose, bent, or corroded, go for complete replacement blades instead. Some Falcons may have been upgraded to beam-style blades, those typically don’t use traditional refills and are replaced as whole units.

Quick tips Falcon owners appreciate:

• Keep the windscreen and refills clean, avoid dry-wiping on dusty glass.
• Top up quality washer fluid, not plain water.
• In alpine conditions, free the blades from ice before operating.

Stick with quality graphite- or silicone-coated refills and the Falcon’s wipers will stay quiet, smooth, and ready for the next squall.

Popular questions about 2013 Ford Falcon wiper refills

What refill type does a 2013 Ford Falcon use?
For factory-style framed blades, most FG-series Falcons use 8 mm metal-backed rubber refills. Owners should still check a current fitment guide for blade lengths and confirm the refill width on the vehicle, as blade assemblies can be changed by previous owners.

If the car has been upgraded to beam/aero blades, those are usually replaced as complete blades rather than with traditional refills.

Is it better to replace just the refill or the whole blade?
If the original frames are straight and the joints are tight, a quality refill is cost-effective and works a treat. If the frames show play, corrosion, or uneven pressure, complete blade replacements will restore wiping performance more reliably.

Plenty of Falcon owners keep the factory frames and refresh only the rubber, but going to full blades is a smart move when frames are past their best.

How often should wiper refills be replaced on a Falcon?
Every 6–12 months is a good rule for AU/NZ conditions, with inspection at each service. High UV, coastal air, and lots of city stop–start driving can shorten the interval. Replace sooner if there’s streaking, chatter, or cracking.

Regular cleaning of the windscreen and the rubber edge helps extend service life between changes.